Search results

  1. R

    Stuffers on crossflow

    They fit the motor that they came out of.----These blocks are all the same.----So it should fit yours.----Tried them in a different position ?-----Turned them around.-----Are there marks from reed petal screws ?----Never had an issue installing them myself.
  2. R

    Fuel primer inop

    Key must be pushed in while cranking for near instant starting.----You must be aware that I have started more than 1 motor with this wonderful primer.-----These primers have been used since 1980 on motors from 9.9 to 300 HP !!!
  3. R

    Fuel primer inop

    Key must be pushed in while cranking it over !!
  4. R

    98 Johnson leaking hydraulic fluid.

    sorry----Last year for the 90 / 115 HP V-4 crossflow was 1998.----Have a 115 myself.
  5. R

    1988 48 special carbs

    A head gasket is cheap at about $30 or so.
  6. R

    1988 48 special carbs

    Cylinder compression may be an issue with this motor.-----Head gasket is cheap.----Take head off and have a look at cylinders.
  7. R

    1988 48 special carbs

    The 88 and 89 powerheads are essentially the same are they not ?-----So why not swap carburetors.
  8. R

    1988 48 special carbs

    Try the other carburetors and good luck with your project.
  9. R

    1988 48 special carbs

    The elusive crankcase compression must not be forgotten !
  10. R

    15HP 93 2 Stroke Evinrude Won’t Start Warm

    " overheated pretty bad "----Means what ?----Wires melted ?----Time to do a compression test and a proper inspection !!
  11. R

    1988 48 special carbs

    Engine is the same from 88 to 89.----Carburetors are simple ( crude ) devices that respond to the air flowing through them.-----If there are issues within the engine then swapping / fiddling with carburetors is a waste of time.
  12. R

    2006 Mercury 9.9hp 4-stroke won't start.

    How did it run for you last season ?----Do you run fuel out of carburetor when storing the motor ?
  13. R

    2.3 Lower Gearcase

    Your local machine shop / blacksmith / highschool could make that bushing.----Strange that this bushing is worn as there is no motion when forward is engaged.
  14. R

    1987 Johnson 15 no spark

    Post your compression numbers.----And when starting do you advance the throttle to the neutral stop ?----Best to ignore the start mark on the steering handle.
  15. R

    15HP 93 2 Stroke Evinrude Won’t Start Warm

    Some simple trouble shooting will quickly determine the issue.----But it can be difficult to convince folks that this is the money / time saving approach.
  16. R

    1987 Johnson 15 no spark

    It can be difficult to see spark on the plugs in daylight.
  17. R

    First time boat owner

    Some sales brochures say----" world class boats "-----Did not appear to be a fact on mine.-----All rotten plywood transom and stringers that needed replacement.
  18. R

    First time boat owner

    What parts are not available ??----Where are you looking for these parts ?----Any part numbers or pictures if what you need ?
  19. R

    1988 48 special carbs

    We can't tell by your post.-----What elevation are you running at ??----What trouble shooting have you done ?
  20. R

    18.5' Winner Quest Restoration

    As long as the foam is dry and not water logged.----They still did have wood in the transom I think.
Top