Search results

  1. alldodge

    LED Bulb trips breaker

    Agree, but nothing else is showing anything, so it's still chasing a ghost
  2. alldodge

    Purchasing 2nd Boat: Jet or Stern Drive?

    Don't forget the jet is not as efficient, but does weigh about 500 lbs less then the larson
  3. alldodge

    LED Bulb trips breaker

    Maybe, I've removed all the outlets before looking for problems, checking connections It is weird that it was only tripping when the fan was connected (on or off), then the next time it was something else. Never liked metal boxes because they were always to small IMO. Might just get some...
  4. alldodge

    Can you search DMV records for a particular car

    Golly gee wiz, the officer can find out how many and where (as in county location not actual address) , which can provide location only info
  5. alldodge

    LED Bulb trips breaker

    Been about a day and a half and fan continues to run. Only thing that is different is I wrapped electrical tape around the side screws on the outlets in the metal boxes. They should have had that before and don't know why they didn't. That said there isn't any way the screws would contact the...
  6. alldodge

    2006 Volvo 5.7 osi-d crank no start

    Maybe, if it has the old nylon covered cam gear, otherwise I don't think so
  7. alldodge

    2006 Volvo 5.7 osi-d crank no start

    Two dead cylinders would be an issue with unburned gas out the exhaust, but it isn't the reason it won't start. There is something else going on It just makes it easier, and if I was willing to spend 4K to find out what's wrong, might as well get someone to rebuild with guarantee cost of a...
  8. alldodge

    New prop for my 1996 2052 capri cuddy

    ok, so if your getting at or close to 4800 RPM when the boat is normally loaded (people, fuel, gear) then your good, IMO. If your on the low side then might be something to work with. If your on the high side then once the prop is replaced the RPM will come down anyway What RPM are you...
  9. alldodge

    New prop for my 1996 2052 capri cuddy

    If your getting Close to or at WOT RPM then get yours repaired or same with stainless Didn't say which 3.0 you have so your WOT RPM can be anywhere from 4400 to 4800
  10. alldodge

    Removal / Fitting Duoprop

    Same with B3 and understand your concern
  11. alldodge

    2 bottom bolt loops on y pipe broken

    If there is enough left may still be good
  12. alldodge

    Removal / Fitting Duoprop

    Don't know the dimensions I set my elbow for torque on props, and never had one loosen or come off
  13. alldodge

    2005 Rinker 232 Cuddy...water in Cuddy

    I have same model just 1995 Should be bow up (just slightly is enough) with plug out for storage
  14. alldodge

    2005 Rinker 232 Cuddy...water in Cuddy

    If its on a trailer then it can come from the bilge. If the water tank is full it can come from it leaking Sitting outside could be rain
  15. alldodge

    1989/1990 4.3 distributor

    You should be able to take it apart and get it going again. Just depends how much labor you want to put in it
  16. alldodge

    LED Bulb trips breaker

    I have 2 other voltmeters with up to 10 amp max. The unit didn't trip (fan off switch on), so I turned the fan on and will see if it trips this 24 hours. The PS on the basement FP is what I made from my old Palm device. It has 2 outputs, 6V and I forget the other. Being old should mean made...
  17. alldodge

    LED Bulb trips breaker

    Circuit tracer, never used one but should make finding everything connected easier i guess
  18. alldodge

    1989/1990 4.3 distributor

    Get a Delco EST kit
  19. alldodge

    LED Bulb trips breaker

    Turned other side of the 3-2 breaker off and think I found every outlet. Check those and found nothing really bad. Did find one which didn't have a ground wire, so the common was jumpered to it, and no ground wire in the metal box. Had the power on all day and night yesterday and no trip...
Top