Search results

  1. alldodge

    Getting 1st Covid/Pfizer shot romorrow

    Just where are your seeing/hearing that, FOX (edit: commentators), News max
  2. alldodge

    TBI 260 Wont Idle When Warm - Will Run other RPM

    Use a small propane torch (don't light it) and move it around the intake a TB base plate. If it starts to change the idle then you found the leak. Can also use WD40 of other things, even water squiring on places
  3. alldodge

    Engine starts and dies.

    Sorry, I knew that and started thinking it was a MEFI instead of a 555 Suggest John at boats unlimited https://www.boatunlimited.com/
  4. alldodge

    TBI 260 Wont Idle When Warm - Will Run other RPM

    I'm thinking vacuum leak
  5. alldodge

    Getting 1st Covid/Pfizer shot romorrow

    All done 2 shots Moderna Most my family are all done and only 2nd shot issues was feeling tired and wanting to stay in bed. Mine was just a sore arm both times, wife the same
  6. alldodge

    alpha 1 gen 1 reverse lock

    Haven't worked on a Alpha in many years, just Bravo for me. You need manual 6 before starting. Without the manual things can go wrong. The list of tools for the lower is called for, but some may be able to use others. Someone like @Bondo or @Bt Doctur can advise better
  7. alldodge

    1988 Bravo 1 oil seal question

    Its on the yoke You do need the manual
  8. alldodge

    alpha 1 gen 1 reverse lock

    The clutch moves FWD/REV and engages one of the gears as the shift shaft is turned. It sounding like the lower needs to come apart because the clutch is not moving This is from manual 6
  9. alldodge

    wiring slave solenoid

    Look close at the top of each cylinders and see if there is a ridge. If there is it will need to be removed or better bored. If no ridge hone the cylinders or at least use sand paper on the rusty cylinders I hope you marked each piston as to the bearing cap and piston or are keeping them as...
  10. alldodge

    TBI 260 Wont Idle When Warm - Will Run other RPM

    Agree, start with fuel pressure test Don't start replacing parts until we know what is causing the issue What's your motor serial number?
  11. alldodge

    wiring slave solenoid

    You said using a 1/2 breaker bar, that is enough to snap the bolt if its stuck. A 3/8 short ratchet would be ok. Best to use the belt to turn it with plugs out Do agree, if your going to rebuild, take it all apart and have the machine shop tank it. Depends on how much your going to do, but...
  12. alldodge

    alpha 1 gen 1 reverse lock

    Yes, I was talking about the shift cable. Didn't think that would do it but your issue has to be the drive or cable Your not going to damage the shaft seal by putting the 2 halves together even if its off one tooth. As BT mentioned, the drive should slide completely together and not need...
  13. alldodge

    alpha 1 gen 1 reverse lock

    Normally it would only happen in one direction. Since it was working fine before impeller replacement, this is what I would check first along with if the cable is attached correctly and not broke
  14. alldodge

    Outdrive leak question

    The list does show 7-10 first and is a good test. Over time there has been many discussions on this topic after Don had passed. These discussion is also where the slight vacuum came in. While it should not have leaked, it did. Try with 5 psi and see if it leaks
  15. alldodge

    alpha 1 gen 1 reverse lock

    The shift foot may be one tooth off when the halves went back together Lower locked counter clockwise Upper shift foot facing forward when the two halves are slid together
  16. alldodge

    Kill switch

    With the lanyard in the switch you want to use the 2 contacts which are connected. With the lanyard pulled those 2 contacts should be open. Connect to the purple wire after the key Don't know which switch, but its probably setup for twin motors and can just use 2 of the contacts for one
  17. alldodge

    Swarm

    Walking back from the shop yesterday I heard a humming. The closer to house I get the louder it gets. Walk a couple steps into the woods and level increases. Never saw what it was but turned around and walked back out. I'm thinking hornets because of the lower drone pitch. About 30 minutes...
  18. alldodge

    Need 4 wire tilt/trim switch

    Well learned something new, thanks. So it has a built in bypass wire
  19. alldodge

    1996 Wellcraft Eclipse Gear Issue

    I would say your issue is in the throttle handle. There are 2 cables and the internal mechanism is not working correctly. Needs repaired or replaced
  20. alldodge

    Outdrive leak question

    Have not seen the issue with cold, but your testing pressure is to high. Better to use 5 psi, and no more then 10 (5 to 7 best) The lip seals face inward, so the higher the pressure the tighter the lip is pressed against the surface. Also goo to test with a vacuum gauge if pressure holds...
Top