Search results

  1. alldodge

    283 flywheel

    With the same part number they should both be the same. The difference in balancing holes most likely was better manufacturing processes for the newer one.
  2. alldodge

    Fuel gauge issues

    Need some clarification Merc uses Pink wire as the sender lead from the gauge Black is ground Normally Green is used as the bonding wire (which also goes to ground) but could be white Where does the Blue wire go to? The sender which was removed was a variable resistor type (240 ohms empty and...
  3. alldodge

    Electric fuel pump issues

    What's the serial number? I'm seeing the 1993 7.4 coming with a mechanical pump
  4. alldodge

    4.3L Volvo (starting out of the boat)

    It can be done with 2 jumpers at the 10 pin plug
  5. alldodge

    Random alarm 5.7L carb'd Bravo 2

    No, and your issue is intermittent so it is hard to find The switch can be below and behind the distributor
  6. alldodge

    4.3 GL Engine Mount Bolt replacement

    Being VP its probably metric Instead of chasing the threads could replace the bolt and nut with anything you want. Do recommend fine thread, but thats about it
  7. alldodge

    VP 5.0Gxi w/ SX-A on 2006 Four Winns H210 shakes when trimmed up

    Don't see the trim pump making the drive shake. Its just a hydraulic pump. With it on the trailer, put muffs on and run it in gear and watch as its trimmed up and down. If nothing is seen, I would take the drive off
  8. alldodge

    VP 5.0Gxi w/ SX-A on 2006 Four Winns H210 shakes when trimmed up

    Something is wrong and needs to be checked out. I would contact the folks who did the work Could be bearing was not installed correctly, U joints or coupler. The U joint should have been checked during bearing replacement, along with alignment
  9. alldodge

    Slack in DPS-A steering?

    Would be normal for cable steering
  10. alldodge

    Random alarm 5.7L carb'd Bravo 2

    It may be a chafed wire. Power goes to the alarm and the Tan/Blue is grounded to sound the alarm. It can be the lube bottle, Temp sender and oil pressure switch. Check the oil pressure switch, it can be Tee'd with the oil pressure sensor which goes to the gauge. 87-864252A01
  11. alldodge

    Engine cut out while slowing down....

    Have been looking at parts from the old 140 to the new 3.0 and the studs, nuts, push rods have been all changed to the newer 3.0 Seeing a different cylinder head part number but that's about it @Bondo have any thoughts?
  12. alldodge

    Engine cut out while slowing down....

    The procedure above is also how the rockers should be tightened to spec. Manual states if not done this way it can bend push rods
  13. alldodge

    Engine cut out while slowing down....

    Agree Did you check clearance of the collapsed lifters? Basically the lifter is fully collapsed and tool is used to see if there is still room to insert the gauge. If its unable to insert then a different length of rod is needed
  14. alldodge

    Lost Propulsion! Need Help! Reply ASAP!!

    Wish you didn't say anything about getting your six pack If you had not said anything about the six pack the following would not have been typed: New boater Pull the boat and get it on the hard. Pull the drive and change the lube, split the drive and rebuild the water pump Pull the fuel...
  15. alldodge

    3.0 OMC 4cyl HELP!!!! SLOW CRANK BUT NO START

    That works, it came with a Holley 2V 2bbl carb Carb kit number 0986794
  16. alldodge

    3.0 OMC 4cyl HELP!!!! SLOW CRANK BUT NO START

    That number isn't coming up What year is it?
  17. alldodge

    3.0 OMC 4cyl HELP!!!! SLOW CRANK BUT NO START

    If it doesn't lock then the cable is broken or something is disconnected Most 3.0 used the holley 2bbl, or Rochester 2GC carb Only way to know for sure is if you can give us the serial number of the motor
  18. alldodge

    Riser Extension Blocks - Full Closed Cooling ???

    Cool beans
  19. alldodge

    New pistol for carry

    Big problem is how to get an auto to use rim fire Other then maybe lugar
  20. alldodge

    New pistol for carry

    Really, thanks My bad, your the best, always thought they were the same
Top