Search results

  1. alldodge

    New pistol for carry

    I have a Kel Tec 380 and its a 6+1 Only good thing is its very small and light
  2. alldodge

    New pistol for carry

    Several make a 22 auto Tarus https://www.sportsmans.com/shooting-gear-gun-supplies/handguns/taurus-pt-22-poly-pistol/p/p47260 Beretta makes a 7 shot
  3. alldodge

    Cool Fuel Pressure Regulator - Testing

    A pump making "more" noise many times mean its sucking air or their is a restriction down stream, or the pump is worn Don't see a tank vent issue because it takes longer for that to show up Don't think you have a low pressure pump, but also don't know your serial number. It may have a boost...
  4. alldodge

    3.0 OMC 4cyl HELP!!!! SLOW CRANK BUT NO START

    Shift into forward and see if the prop locks in one direction, then shift to reverse and see if it also does it. That said, you should remove the drive, drain the gear lube and replace the impeller in the drive, and may need to rebuild the pump. Pressure test the drive after impeller...
  5. alldodge

    Can't seem to find a big enough fuse block

    Normally the 12V/120AC will automatically switch over to 12V when shore power is disconnected. That said there is usually a breaker on the 12V side, or could be a fuse and a switch. Might be the 12V line is not connected What size house bat does it have?
  6. alldodge

    3.0 OMC 4cyl HELP!!!! SLOW CRANK BUT NO START

    Remove all the lines and see if they need cleaning or replacement Can spray some carb cleaner thru the lines to help Remove the fuel filter and replace and clean it, but this depends on which filter is installed
  7. alldodge

    3 blade prop

    He does not want one to pull skiers The big IF If the PO change to 4-blade and did it right then they would have dropped 2 inches of pitch. Meaning if the boat came with a 3-blade 19, they would have gone to a 4-blade 17 If they didn't do it right, then it may be same pitch Hope someone...
  8. alldodge

    Engine starts and dies.

    OK, then need to start looking on the electrical side. The injectors are not being turned on/off ( Can you scan the the motor for codes? Can make up a scanner with a 12V resistor LED or use a digital multimeter that has a tone function if (Big IF) you have a MEFI ECM which looks like the one...
  9. alldodge

    3 blade prop

    Howdy Bob Keeping rpms low on the WOT side doesn't save gas or help the motor, it actually is worst on both To determine what pitch is needed we need some good numbers of what its doing now. What is current WOT RPM and loaded like normal? What is the speed at WOT using a GPS? What type and...
  10. alldodge

    Helm/console wire diagram

    Try this
  11. alldodge

    Penta 4.3 GLA distributor cap wiring

    Firing order for a GM V6 is 1-6-5-4-3-2
  12. alldodge

    Engine starts and dies.

    OK, and does the pressure stay at 55 psi when pouring gas?
  13. alldodge

    1996 Horizon 220 5.0Fi raw water pump issues.

    I don't think its the pump Think either the hoses are on wrong or there is a restriction
  14. alldodge

    Can't seem to find a big enough fuse block

    See if you have a breaker or fuse on the 12V side for the fridge. If one is there then it will switch to 12V when shore power is removed. If nothing on the 12V side, no go
  15. alldodge

    Engine starts and dies.

    Here is the GXi
  16. alldodge

    Engine starts and dies.

    Its an OSi which is same wiring as GXi The ALT powers the ignition, he has spark but is not getting fuel. The fuel pump is running just need to know if it stays running when gas is being poured in, or does it shout OFF. This drawing is from a Gi but the wiring for the fuel pump and ignition is...
  17. alldodge

    Help me understand how to wire a shoreline float switch....

    Your saying a shoreline float switch, but then mention 3 wires. What I think your talking about is a bilge pump with built in float switch? If that is the case, use the pic Ding posted and note the 3 wires coming from the pump and switch. One is ground, the other 2 are used to turn it ON
  18. alldodge

    Engine starts and dies.

    This motor doesn't use the ALT or the oil pressure switch to keep pump ON Was that while running (pour gas down throttle body), or just with key ON?
  19. alldodge

    Volvo trim sensor

    Yes it can, but you take the chance of a bad connection later. Many use adhesive shrink tubing to seal the soldered connection
  20. alldodge

    Can't seem to find a big enough fuse block

    18 circuits for a 24 footer is a bunch. Could use an automotive block but would need to bypass the 4-way and turn single flasher Could use individual breakers and make your own panel
Top