Search results

  1. R

    99 Johnson 50hp 2cyl? Any good?

    Your motor----J60ELCUC-----Appears to be the 49 cubic inch block.-----That service bulletin DOES NOT APPLY.
  2. R

    Fuel Delivery Mystery

    Top 2 carburetors work ( meter out fuel ) at idle.----Bottom 2 carburetors start working at about 1800 RPM + or so.
  3. R

    1955 evinrude 25hp wont stay running unless fuel primer bulb is being pushed. Help please

    What ?????----You are talking about a plastic tank and a primer bulb.-----Then we are talking like you still have a steel tank and the pressure system without a fuel pump.----Pictures needed as I know these motors very well ( have one myself ) but I am confused by your set-up !-----You can not...
  4. R

    99 Johnson 50hp 2cyl? Any good?

    Start by posting your model #----This service bulletin does NOT apply to the 49 cubic inch motors.
  5. R

    1955 evinrude 25hp wont stay running unless fuel primer bulb is being pushed. Help please

    Sounds like someone converted from a pressure tank ( double line hose ) to a single hose with a fuel pump.-----So without pictures or hands on I can't tell.----Not everyone does this swap correctly.
  6. R

    Loss of power, won't plane

    I do not believe there are any " vacuum " hoses on this motor.-----Hoses for oil recirculation and electric primer valve hoses.----t is the design of the top piston ring that is at fault here.-----I can't believe they stuck with that design for 20 years after first issues showed up.---Install 4...
  7. R

    99 Johnson 50hp 2cyl? Any good?

    The 3 cylinder was marketed for a few years as a 50 / 60 / 70 HP model.-----The service bulletin to relocate the tell tale came out in 1994 for the 56 cube models.----I think all factory 3 cylinder production after 1994 had the tell tale hose coming off the top of the block.
  8. R

    1975 Johnson 115 starter motor

    On a salt water motor it could be a challenge.-----May have to change out the entire swivel bracket to put the 1980 T&T on a 1975 model.-----Look this over / measure carefully.
  9. R

    1975 Johnson 115 starter motor

    ??----You can test the spark pulling it over with a rope !----That motor can be started with the battery completely dead.
  10. R

    1975 Johnson 115 starter motor

    Those magnets only break if it is dropped on the floor or hit with a hammer.----Do an ohm check on your armature.----If good there , must be a local shop with good magnets in your area.
  11. R

    99 Johnson 50hp 2cyl? Any good?

    The 2 cylinder 50 HP was first marketed in 1971.----They made a lot of them since then.-----If you are looking at a used one then condition is everything !
  12. R

    Excessive voltage when running 1992 Johnson 115SPL

    Factory unit appears to be less than $150.------Need a new gasket too.----If you can pull the flywheel yourself you can save $100 shop fees.
  13. R

    1996 Force 120 with crazy compression numbers

    Remove bypass covers and have a look for condition of pistons / rings.----All easy to do.
  14. R

    58 evinrude 7.5 cooling problem

    Nearly impossible to assemble those pumps so they will not pump !!
  15. R

    1975 Johnson 115 starter motor

    Do an ohm check on armature.-----Should read infinity from commutator to shaft.----Looks like it was git with a hammer because it did not work.----Used starters are plentiful in my area.
  16. R

    1962 Merc 450 restoration ..

    I think you will find the spring is there.----It be inside the prop shaft !
  17. R

    No Power When Cold - 1985 50HP

    A 1985 model has ADI ( alternator driven ) ignition , no points anywhere near that motor._ I would look at opening the low speed mixture screws 1/4 turn each and see if that gets rid of the bogging in cold weather.-----And you absolutely need to verify that both carburetors are clean.-----A...
  18. R

    Do you park your vehicle straight into your garage or back in?

    -----It is the build up of CO ( carbon monoxide ) that is the silent killer.----Not CO2
  19. R

    Electric Boats

    So if I have the numbers right if an EV ( boat or car ) is plugged in and charging at 72 kilowatts then 100 HP must go in / come from a generator somewhere to do that.---During that Texas cold snap they say it was costing up to $900 to put a full charge into a high end EV.-----Quite high I would...
  20. R

    1996 130HP Evinrude PowerPack test question

    The S.L.O.W. system is also triggered by an overheat condition.----I would look at the water pump first.
Top