Search results

  1. alldodge

    Guardian Mode Alarm Help

    The key is max rpm exceeded On the shift plate is a "in gear" switch, and if the PCM things its in neutral then when 3200 rpm is exceeded it throws the error and alarm Unplug the switch and see if that fixes it
  2. alldodge

    Alt Gauge Help

    Here is the GL-E wiring
  3. alldodge

    Chrysler 125 removal

    Question is did I get them all? Think I got all the fastener's (11 total) off and think its just the silicone holding but want to make sure There are 2 nuts on right rear and 3 nuts on left rear side There are 6 bolts on the top plate There are 2 other bolts which I have not removed and there...
  4. alldodge

    Engine Hesitation/Fuel Issue - 1995 Crownline BR202

    Howdy Sounds like its the tank vent line The fuel tank must be vented, otherwise as the fuel is pumped out the tank starts to draw a vacuum. With it taking 60 to 90 minutes to do this, is a real sign that is most likely the problem To prove it out, when motor starts to bog, stop and open the...
  5. alldodge

    Chrysler 125 removal

    Thanks Jerry, this is what I was thinking, but some of them are so tight I was thinking about removing some of the linkage and brackets to get at it Makes me wonder just how were these built on the factory floor.
  6. alldodge

    1994 5.7 liter won't start

    Your serial number is coming up as a carb, not understanding the term "manifold" with reference? I'm seeing TBV ignition. I know you said there is good spark but have you tied the TBV trouble shooting guide
  7. alldodge

    Chrysler 125 removal

    Should be simpler then I'm seeing. What bolts are removed to lift motor off the leg?
  8. alldodge

    Wiring help needed 4.3L TB-IV

    Do this to start and run
  9. alldodge

    2002 Tahoe 202 - Mercruiser 5.0 MPI fuel pump not priming

    There are 2 other connections
  10. alldodge

    Outdrive wont go back on!!!!!!

    It goes in and out with 2 fingers and drive will not go on, I would say there is something wrong with your alignment tool If different spacers are needed, then need to look close at the rear mounts, they may need replacing Was the gimbal bearing replaced, and if so are you centering it...
  11. alldodge

    Not Turning Over, Low Compression, Mercruiser 3.0

    How to start
  12. alldodge

    SC1000 Smartcraft gauge can't read digital readout

    Boat yard installed motor and gauges, so why doesn't the boat yard fix the issue, or have you asked? If the tank is not connected to the CAN network then it doesn't know. If it is connected, then once programed, and gass is added, it will calculate how much is left based on the level Is your...
  13. alldodge

    2002 Tahoe 202 - Mercruiser 5.0 MPI fuel pump not priming

    The MPR sends power to 2 other fuse, one of which is for the FPR. When MPR connects there should be 12V on pin 85 and 30 (not 86) on FPR along with connection to the IAC. So there is a bad connection or MPR coluod be the issue
  14. alldodge

    Looking for scamatics

    This is about the only one I have for OMC
  15. alldodge

    4.3L Mercruiser Won't Start

    Dang, let me go dunk my hat in the creek. A 2011, not a 2001 but 2011 with a TKS, I never would have thought that OK, I'll go with it but TB ignition is not longer available So you used the TB% troubleshooter?
  16. alldodge

    4.3L Mercruiser Won't Start

    Flat cap is what most call carp cap because they are always going bad, but are the HVS distributor and look like this CAT's mean catalytic converter exhaust system
  17. alldodge

    mercruiser 5.7 hard start fuel pump/oil pressure switch?

    I'm thinking the electric fuel pump was added to the motor later. In 1995 the SBC had a mechanical fuel pump unless it had TBI. It needs a 3 prong switch and would be wired like this...
  18. alldodge

    mercruiser 5.7 hard start fuel pump/oil pressure switch?

    The starter powers the fuel pump (Purple/Yellow) when the motor is cranking. Once the motor starts and oil pressure builds, then the switch sends power to the pump Check the purple/yellow wire coming from the starter
  19. alldodge

    Alt Gauge Help

    The voltmeter does connect to the purple wire but it would connect to it at the helm, not at the motor. Each gauge will be daisy chained to the purple coming from the key switch
  20. alldodge

    Volvo penta 7.4gi loss of top speed perhaps tied to slight thermostat overheating?

    Pressures
Top