Search results

  1. alldodge

    1999 4.3 mercruiser spark, oil pressure, no fuel?

    This is in the OB section and should be in the Merc section GA_Boater There should be a Purple/Yellow stripe wire coming from the outboard small post on the starter. This is the wire which feeds the pump while the motor is cranking. Once it starts, power is removed from the Red/yellow until...
  2. alldodge

    Lose power to everything except trim switch on 2004 caravell 187bw mercruiser 4.3

    If your not getting power thru the fuse its blown. The fuse is replaceable https://www.ebay.com/itm/Bussmann-CBBF90-CBBF-Battery-Fuse-/164317075140 Remove the fuse and have a look Most have all the wires attached to the fuse, when actually only need the orange wire. The fuse is used to...
  3. alldodge

    Engine install and align. what am I doing so wrong??

    Is the bar made to spec?
  4. alldodge

    Mercruiser alarm only at idle

    Thank, Carb motor The switch and sender are both port side low where the remote oil filter is connected. The sender is item 8 and the switch is item 10. Look at your part number listed to see if it was the sender or switch Sender 8M0068784 Switch 8M0070108 Not having a ECM but do have a TB5...
  5. alldodge

    Kill switch

    Yes, you on the right path
  6. alldodge

    Engine install and align. what am I doing so wrong??

    The bearing doesn't look good but that's a different issue maybe This is how it should go together The mount either uses a spring washer OR the fiber washer, not both. All depends on what transom assembly is being used
  7. alldodge

    2002 3.0 Electronic Timing Help Needed

    The timing advances by moving more Before TDC Wires on shunt and shift interrupter are connected and disconnected with the motor running. Don't know your serial number but timing of the 3.0 can be anywhere from 1* BTDC to 2* ATDC Serial number break: 0L096999 and below - 1 BTDC Serial number...
  8. alldodge

    Squeal when boat first starts

    Taking the battery cable off the battery may have just blown the regulator in the alternator. The old remove the battery cable on cars use to work, but even now it can blow the reg in the ALT Agree its the ALT, but the belt is not tight enough or the belt is not the right size. Looking at the...
  9. alldodge

    Mercruiser Bravo ONE lower shift cable replacement

    Do not drill it out The outer jacket is removed and installed from the drive side There are 2 different cables used and depends on which year you have. In the link below is the manual and how to replace the cable http://boatinfo.no/lib/mercruiser/manuals/mercruiser11.html#/316 Folks make a...
  10. alldodge

    Running cold

    Being a 2011 it should have CAT's (catalytic converters) and have a PCM 09 I'm thinking the poppet valve (item 15) which has had many troubles
  11. alldodge

    1987 OMC King Cobra 5.0 Alternator Issue

    Howdy Something is miss-wired and don't think its at the ALT, maybe at the trim pump or starter. Here is the OMC wiring diagram, and look thru to see if wiring is correct
  12. alldodge

    Chrysler 130

    Started taking the from apart, its taking a lot of heat to get it to budge. One side Then the other Got the hydraulic trim off after mire heat but didn't take a pic Removed the clamps (or what ever their called) from the bottom which holds the center turning shaft. The bottom bolts...
  13. alldodge

    Guardian Mode Alarm Help

    Check the wiring to/from PCM, it might be shorted to ground For your motor, don't run it until impeller has been changed. Your pump is barely working and won't take much for it to stop and then it can be damaged
  14. alldodge

    not getting fuel

    Being a carb motor I'm going to assume its a GL, but a GL what? The GL uses feed from the Key switch (yellow/Red) to energize the start assist relay and the fuel pump relay. The feed to energize the FP relay goes thru a diode. If the diode opens then the relay is not energized. Once the...
  15. alldodge

    Cabin heater core blowing cold air.

    OK, I understand better, the issue is showing open cooling system and talking closed and heaters For coolant to circulate thru a heater it needs to go from a higher pressure area to a lower pressure area. The low side needs to be on the circulating water pump (left side facing motor) or Tee'd...
  16. alldodge

    Chrysler 125 removal

    Got it out
  17. alldodge

    Cabin heater core blowing cold air.

    Your motor will over heat if the red one is plugged. This is the flow of fresh water from the drive The ones in white would go the the exhaust manifolds If your trying to install a HE on the motor, lets start with, what motor, what year and serial numbers are best
  18. alldodge

    1993 OMC Cobra 351 EFI Ford 5.8 how to start?

    Don't know if the wires will fit, don't know what motor they are for. Do know that marine wires need to be longer because they go under the manifold instead of over Take the hose that would come from the outdrive going to the thermostat housing and connect the garden to it. The pic below are...
  19. alldodge

    7.4L MPI (L29) MEFI 2 Fuel Pressure issue

    This is what they look like
  20. alldodge

    1993 OMC Cobra 351 EFI Ford 5.8 how to start?

    Using a sander will make it look nice but will not be flat. If it was put on a lathe this would work, otherwise would need a flat file but that would take a long time Wiring
Top