Search results

  1. R

    Help! Need advise!

    Round of applause for above post #8
  2. R

    1973 Chrysler 6 HP Two Stroke

    Chrysler became Force-----Bought by --Brunswick Corporation ( Mercury Marine)-----So your local MERCURY dealer might be able to help if you show the part numbers for the 76 model.----Failing that any bearing shop can measure seals and come up with a match.---Measure seals / housings /...
  3. R

    1989 Johnson 90horse VRO issues

    The VRO pump runs off PRESSURE pulses from the crankcase.----The wiring is just for the " no oil " alarm.----If you premix in your tank there is no need for this electronic module.----Best option is per post #3
  4. R

    Johnson 70 hp 3 cyl / 2-stroke dies when giving more throttle

    See post #4 ?----And who cleaned the carburetors ?----Does spark jump a gap of 3/8" on a test device , yes or no ?
  5. R

    1989 Johnson 90horse VRO issues

    The elegant / simple thing to do is to mount a 2 nipple pump.----This pump mounts directly over the pulse port on the intake manifold.----Leaving the VRO unplugged has no effect on starting.
  6. R

    Johnson 70 hp 3 cyl / 2-stroke dies when giving more throttle

    I have lots of ideas of what to check.-----But your reply has been negative on the timing light check etc.------And I stated that reeds rarely cause a problem , so here we are .----What would you try to look at next yourself , bases on what you have seen so far ?
  7. R

    Tilt/trim manual hydraulic screw won't tighten

    Did you remove the clip inside the hole ?
  8. R

    9.8 Running on One Cylinder Only

    And how did you determine it is a bad trigger ?
  9. R

    Tilt/Trim For a 73 Evinrude 85hp

    I doubt it.-----Or should I say----No it is not a straight forward swap.----Nothing is compatible between these 2 motors.
  10. R

    FUEL LINES PLUGGING

    Folks will always buy something because it is cheaper.-----There are factories prepared to supply this stuff !
  11. R

    1988 Mercury 115

    I often tell folks to install a new impeller on recent purchases.----Something that has been proven over 50 years of work.-----A very common reply is ---"my water pump is working fine "------Folks just do not realize that many motors do not have an overheat warning horn, or if it actually works...
  12. R

    1988 Mercury 115

    Wow----Some folks are offended when you tell them like it is.----When I went to school teachers told you you were wrong and deducted marks !!----A different world today.----Good luck with the tower of power.
  13. R

    1988 Mercury 115

    Those motors need a new impeller about every 3 years.-----Your choice to gamble.----It can be hard / difficult to teach all the novice boaters about maintenance these days.
  14. R

    9.8 Running on One Cylinder Only

    Put your own timing marks on for top and bottom cylinder.---Start motor and use the timing light.
  15. R

    1988 Mercury 115

    Check spark.----Sounds like it might be running on 3 cylinders.----Stop running this motor.----If it was a blocked carburetor it would starve 2 cylinders of gas and OIL .-----You should install a new water pump impeller too.----Test the hot horn as well.----Running with 50:1 mix or something else ?
  16. R

    Proper Way to Test Compression on Non-Running Motor

    That is classic damage to the original coils.----All the motors with those coils from the 1950's / 60's / 70's will have that happen. ----Used on the 3 / 5.5 / 6 / 7.5 / 10 / 15 / 18 / 20 / 25 / 28 / 33 / 40 HP motors.----Every boat shop that works on older motors will have them on hand...
  17. R

    Johnson evinrude 1989 V4 140hp overheating

    Yes it has that water control valve on the side of the block.-----And there are no water deflectors on this motor.----Water deflectors are on the crossflow motors , not the loopers.
  18. R

    Spark plugs for my 1973 65 hp Triumph

    A good ignition on those jumps a gap of 1/2" with ease !
  19. R

    Why would the electrode on a spark plug get smashed

    Are / were all 4 plugs the same on this motor ?-----Length matters !-----This should be easy to solve.
  20. R

    1969 evinrude 6 impeller size

    ????-----The 79 model 6 HP and only the 79 models came with the smaller impeller from the factory.-----But your motor has had the 79 kit installed.-----Nothing wrong with that.-----So order the 79 impeller and install it.-----Maybe it is clear now ?----The smaller impeller pumps plenty of water.
Top