Search results

  1. Scott Danforth

    No water out transom or exhaust

    Water from the transom shield hose should spray about 8-10" out the hose at idle
  2. Scott Danforth

    No water out transom or exhaust

    Start at the impeller and work your way thru the system. And yes, impellers can toast within 20 seconds without flow. Even if you have muffs
  3. Scott Danforth

    Record crappie

    in the early 80's, about 83, Dad and I were fishing the Menomonee River, just above Chaulk Hills power station. he caught a crappie that was about 3#. it hung 1" over each end of the frabil minnow bucket. the bucket was 14" in diameter. we ate it. however had we kept it, it would have been...
  4. Scott Danforth

    Hull liner

    its in my build thread in the sig
  5. Scott Danforth

    NEED HELP QUICK PLS: Replacement Engine choices for 350 MPI

    remember, your local engine machine shop guys probably are the best resource you have. Depending on how you want your build, you may need to go that route. for a stock block, Summit or GM direct for the scat rotating assembly - Competition products out of Oshkosh WI with your motors being...
  6. Scott Danforth

    Hull liner

    Go to any RV supply. Like Panther RV Its $6.55/ ft Same crap other places charge more for Panther also has wider than the 72"
  7. Scott Danforth

    Boat mooring in rocky areas (aluminum boat)

    Keel guard, pull boat up on shore
  8. Scott Danforth

    Installing an inverter

    The inverter instructions will have this info. However you may want to look at what you typed. For what you typed, you would be looking for a step- up transformer and diode pack. AC to DC Inverters are for going from DC to AC
  9. Scott Danforth

    Bow plowing at high speed.

    Your bunks should extend to just aft of the transom. Maybe move your winch post forward. May be impossible to get the hook out
  10. Scott Danforth

    Gross trailer weight rating

    Your first question was how.... i answered. It was a statement not a question
  11. Scott Danforth

    Gross trailer weight rating

    Your tongue weight......
  12. Scott Danforth

    Marvel Mystery oil in a 2004 5.0 engine

    Any compression reading higher than 150 is either a bad gauge or oil in the cylinders You may want to check your fuel pressure against spec Its not your ECM or coil
  13. Scott Danforth

    1998 Bayliner Capri floor.

    Use a goos shop vac with a bag, use duct tape to hold the hose near your work to suck as much as possible It helps
  14. Scott Danforth

    Advice on transom , stringers and floor rebuild

    Is there a reason you want to use epoxy? Your boat was poly resin If it was me, laminate ACX exterior plywood with titebond III, make new transom, stringers and bulkheads. Tab in with CSM and 1708 Drop in floor and tab in, foam Cover with 1708. Finish with gel
  15. Scott Danforth

    NEED HELP QUICK PLS: Replacement Engine choices for 350 MPI

    Stock build is a mediocre motor with stock GM flat topped pistons and pressed pins vs propper LCQ pistons and floating pins. Difference is between 100-125 lb-feet and a fatter torque curve (about 50-100hp more) if you build it right yourself Seacore is just a fancy name for HX cooled Up to...
  16. Scott Danforth

    Arrow Glass Manual for starter problems?

    Start by cleaning all connections Then dig deaper if that doesnt help. Sorry you bought a boat with a 470
  17. Scott Danforth

    Mercruiser 3.0 Rebuild or not

    I would never rebuild a 3.0. to rebuild one will cost your $1800 to buy a good running 3.0 in a rotten boat is only $300 +/-200 i agree with everyone above, run it.
  18. Scott Danforth

    Filler Size Applications?

    I always mixed both chopped fibers and fumed silica (cabosil) I also use the fumed silica to make thickened resin for non-skid
  19. Scott Danforth

    1973 brochure?

    have you tried this: https://www.starcraftmarine.com/resources/request-brochure
  20. Scott Danforth

    Replacing stringers

    go to the stickies..... https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/ read links 14, 15, 18, 2, 3, 4a, and 4b. look at every picture, watch every video, read every post in the threads then determine is this something that you CAN do or want to do we cant...
Top