Search results

  1. Scott Danforth

    Trailer on a Suntrack Party crusier 32

    If you cant drop the drive completely, you may be longer than you think To put my searay in the garage, I had to back the trailer up on ramps to be able to drop the drive completely. That was only way to get the boat backed in far enough
  2. Scott Danforth

    Understanding how engine died - water on inlet and exhaust sides

    Minimal air to valley, however with all the rust under the valve covers, i would be using a brand new intake
  3. Scott Danforth

    Trailer on a Suntrack Party crusier 32

    Can you drop the drive completely when on the trailer?
  4. Scott Danforth

    Just 3 Words

    New impeller coming
  5. Scott Danforth

    Understanding how engine died - water on inlet and exhaust sides

    because it sat with moisture in the oil
  6. Scott Danforth

    Heavy weight seat mounts & swivels

    I have purchased from USC in the past. however I now have an account at FGCI since its near work. much cheaper to buy from a large local source than ship. I would try Northern Composites in Hampton NH otherwise, expect to pick up about 10 gallons of resin alone plus your CSM and 1708
  7. Scott Danforth

    Trying to determine the age of this 14" Seafarer before I start restoration.

    what does the paperwork say it is..... Bill of Sale, signed registration card or title? without paperwork, its a 2020 yardplanter
  8. Scott Danforth

    Just 3 Words

    low tide boating -6" below chart channel moved 20' ran aground again got towed in
  9. Scott Danforth

    Overhauling my 1988 MerCruiser 4.3 ltr. engine

    nice beach marks
  10. Scott Danforth

    Building a '93 Caravelle 1750 Classic Bowrider

    not to shabby.
  11. Scott Danforth

    Heavy weight seat mounts & swivels

    where are you located? there may be a local fiberglass supply house. that would be cheaper than shipping as you get hit with EPA fees for shipping resin.
  12. Scott Danforth

    Repairing rotten wood on bass tracker deck!

    if you want to leave it outside, suggest a cover. even if you used coosa board and line-X XS-650 on the deck. UV will make a mess, and the flotation foam will be gone in a few years. A cover over the boat at a minimum will allow you to put a wood floor and carpet back in and allow you to keep...
  13. Scott Danforth

    Clip for wiring harness

    I simply shove the end of the wire into the winch
  14. Scott Danforth

    Heavy weight seat mounts & swivels

    i agree with Frogy, I would set asside about $3000 for this project (all materials and PPE)
  15. Scott Danforth

    Wisconsin title.

    Wisconsin never had registration on motors as far back as I can remember. No trailer titles until over the 3000 GVW as indicated.
  16. Scott Danforth

    Bilge Pump through hole fitting

    two common sizes are 3/4" or 1-1/8" need to measure
  17. Scott Danforth

    Intermittent oil pressure readings

    first welcome aboard second verify oil pressure with a mechanical gauge. third, if oil pressure is good, start looking for something faulty on the electrical side.
  18. Scott Danforth

    Heavy weight seat mounts & swivels

    you currently have back-to-back seats which are extremely common on boats from the 60s-90's as stated, the floor is always the last to rot. if when you pull the carpet up, you find a layer of fiberglass on the floor, it is the original floor. if you pull the carpet up and there is wood under...
  19. Scott Danforth

    Mercruiser 6.2L MPI overheating

    overheating is from lack of cooling water flow check the line from the pump to the pickup. including where it goes thru the gimbal. backflush as needed. check your PS cooler and cool fuel module for plugged tubes. check the poppet valve. 35 hours on a 4 year old boat is not many hours...
  20. Scott Danforth

    SeaDek

    great on the feet, however EVA foam is same as flip flops. they stain if you drop wine on them.
Top