Search results

  1. H

    anyone have luck with aftermarket v/p fuel pump assy?

    Any recommendations for a an after market low pressure pump? The carter pump seems to come with different (threaded) fittings. Is it possible to swap over? My LP pump has been whining for two seasons now. Still works, fuel pressure is within spec on both low and high side, raw water flow seems...
  2. H

    Neutra-Salt: Connect to power steering cooler?

    I will eventually, just wondering if anyone had the answer.
  3. H

    Neutra-Salt: Connect to power steering cooler?

    I'm almost certain it's a hose barb. It's the fitting where part 17 (a rubber cap) goes in the diagram below.
  4. H

    Neutra-Salt: Connect to power steering cooler?

    I have a VP 5.7GXi-HF, serial 4012221122. Going to install a Neutra-Salt system. On the power steering cooler, there is a spare port which is blinded. Does anyone know if this port tees into the raw water cooling or the power steering fluid?
  5. H

    Engine problems while on vacation

    Not necessarily. Look up mancavemechanic on YouTube. He has some nice videos on rebuilding the fuel cell. Strip down the entire unit and remove the interior paint. I’ve done this myself and replaced all the o-rings while I was at it. Regularily inspect the screen just to stay ahead of things.
  6. H

    Engine problems while on vacation

    Did you check the fuel pressure regulator screen for debris?
  7. H

    5.7 GXi-HF pressure in power steering reservoir

    Every time I check the power steering fluid level there is a hiss when opening the filler cap/dipstick. Is the power steering reservoir supposed to be pressurised like this with the engine off (sometimes for days)? A bit of background info: Last season I opened the engine compartment, only to...
  8. H

    5.7GXI age/value

    If you go to the Volvo Penta website and use the engine serial number to search for operators guide and workshop manual, you can see the the engine specifications. https://www.volvopenta.com/your-engine/manuals-and-handbooks/ The 5.7GXI-B was manufactured between 2001-2002. Your engine has a...
  9. H

    Trim sender: 2-wire or 3-wire?

    Thank you , I'll do the measurements like you suggest.
  10. H

    Trim sender: 2-wire or 3-wire?

    I looked in the document mentioned in my previous post and it does not contain much beyond removing and installing the sensor as well as measuring 11 Ohms between the two wires with the drive fully down. My sender does not have the connector. The wires have been cut and spliced with butt...
  11. H

    Trim sender: 2-wire or 3-wire?

    Would that be the "Sterndrive AC 2(2) Workshop Manual"?
  12. H

    Trim sender: 2-wire or 3-wire?

    VP SX-M transom assembly (serial no 4151128936, prod no 3869341). Drive is a DP-SM, engine is a 5.7GXi-HF My trim gauge is intermittently displaying 56 and sounding a warning. I'm still able to tilt the drive up and down, engine starts regardless. This usually happens as I turn the key (before...
  13. H

    Overheating under load

    Are you referring to the seal for the cooling water intake between the pivot housing and upper gear housing? If this seal is broken, the pump will suck air when the boat is on plane. That could be the cause of your overheat issue.
  14. H

    Water leak at the transom

    That’s a great suggestion, hadn’t thought about that. Thank you! Would anyone, by chance, know the dimension of the bolt heads?
  15. H

    Water leak at the transom

    I have a similar issue with my VP 5.7 and DPSM drive, but mine apparently only leaks when the engine has been run. Pulled the drive last fall and the bellows was dry. I therefore suspect a leaky seal between the y-pipe and the transom assembly, but have yet to confirm this (boat is currently on...
Top