Search results

  1. T

    Is my motor sitting to low?

    No problem just wondering haven't had boat long
  2. T

    Is my motor sitting to low?

    I believe it is a hollow bottom
  3. T

    Is my motor sitting to low?

    I've seen a lot of post about how the top of lower unit should be even with the bottom of transom is my motor too low? It's in the top hole so I could raise it?
  4. T

    Shifting into reverse is really hard

    Thanks for the info
  5. T

    Shifting into reverse is really hard

    Will do I'm in the middle of restoring it so as soon as I get it all back together I will
  6. T

    Shifting into reverse is really hard

    I'll give that a try thanks
  7. T

    Shifting into reverse is really hard

    No I wasn't
  8. T

    Shifting into reverse is really hard

    Got a 2000 evinrude 50hp 4 stroke when I shift into forward it very easy, but when I go back to neutral it gets a lot harder and then if I shift to reverse it's really hard to shift but will go back out of reverse to neutral easy and then to forward easy. Cables are new I unhooked the cables at...
  9. T

    Wiring 2000 evinrude 4stroke

    Yea it’s original 2000 odyssey pontoon with 2000 evinrude 4stroke 50 hp I think the 3pin plug is pink fuel black ground and blue is light for gauges
  10. T

    Wiring 2000 evinrude 4stroke

    Putting new wiring harness in pontoon, the new harness came with 9pin plug for helm but old harness also had a 3pin plug for helm and a 9pin plug, the 3pin plug has a black blue and pink wire, pink wire comes from fuel gauge goes to fuel tank and black is ground the blue comes from tach but...
  11. T

    Water pressure valve replacement 2000 evinrude 4stroke

    I’ve already replaced thermostat I’m talking about the water pressure valve but thanks
  12. T

    Water pressure valve replacement 2000 evinrude 4stroke

  13. T

    Water pressure valve replacement 2000 evinrude 4stroke

    This isn’t where the manual describes it but the only thing I could find that resembles a poppet valve is on starboard side of engine below rectifier is a housing with two bolts with yellow paint on them could this be it?
  14. T

    Water pressure valve replacement 2000 evinrude 4stroke

  15. T

    Water pressure valve replacement 2000 evinrude 4stroke

    I thought it was very odd placement myself and why I’m very hesitant to pull it all apart to replace it that’s a lot of work for preventive maintenance but if it really needs to be done I will do it.
  16. T

    Water pressure valve replacement 2000 evinrude 4stroke

    I have the evinrude manual
  17. T

    Water pressure valve replacement 2000 evinrude 4stroke

    Where is it then? The manual says below oil reservoir?
  18. T

    Water pressure valve replacement 2000 evinrude 4stroke

    No salt water been fresh water it’s whole life
  19. T

    Water pressure valve replacement 2000 evinrude 4stroke

    New to the boating world and have been trying to get this 2000 evinrude 50hp 4stroke/ Suzuki ready for the summer I’m trying to do any maintenance that should have been done boat sat for 3 years, it does run good took it out several times at end of last season. My question is the water pressure...
  20. T

    What prop to use 50hp evinrude

    I did get a few hundred more rpm out of the 13x11 around 5500
Top