Search results

  1. G

    Bravo II Drive

    Hello guy's I have a 1997 Bravo II drive that you have to push pretty hard on the remote shift handle to make it shift. So far I have replaced the remote shift control,lower shift cable {after lubing with light oil } , cleaned and greased shift linkage in upper drive and it still shifts pretty...
  2. G

    Exhaust leak

    1997 Mercruiser 350 L full closed cooling. I have an exhaust leak and need to install a new gasket, do I have to drain all the coolant or just below manifold level ? Thanks
  3. G

    Any Idea's on flush valve ?

    I have a 1997 5.7L 350ci Mercruiser Bravo II XL with closed cooling. I want to install a flush valve other than down in the bilge. There is no shut off valve. Only have to flush heat exchanger and risers ? Thanks for any help.
  4. G

    water pump impeller

    Just to make sure, what way do I turn the impeller to seat it in the housing on a 6 hp. evenrude ? Thanks
  5. G

    Opinions on exhaust manifolds

    Going to change out the exhaust manifolds and risers on my 1997 closed cooling 5.7L Mercruiser 350 LX, am I better off going with the newer dry joint set up or stay with the old style ? Thanks
  6. G

    1986 6hp. Evenrude E6SLCDE

    Guy's does this motor have a tell tale ( pisser ) to tell if the water pump is working ? Thanks
  7. G

    Apprarisal for Boat

    Hello; Hope this question is in the right place. I can not find the selling price for a 1996 22foot Aquasport C/C with a225 Evenrude Ocean Pro. Can anyone tell me where to look ? Thanks
  8. G

    Oil level

    Maid a mistake while changing the oil in my 350 c.I. Mercruiser. I now have oil level about one half inch above the full mark on the dip stick. Does this have to come out before starting the motor ?If I can run it to warm the oil up I will bring the level down. Thanks
  9. G

    S/S Prop

    Any one have any tricks to keep a S/S prop from getting the crap on it when slipped in the salt for six or seven months ? Thanks
  10. G

    Cone Clutch Shift Bravo II

    Hello; I have a 1997 5.7L LX with a Bravo II drive. The drive is very hard to shift. I have replaced the shift cable and the helm shifter also lubed everything.Also pulled the cover and cleaned the shift d-tent and applied new grease , and the drive still shifts hard. I have to push and pull the...
  11. G

    1990 Force 150 hp.

    Changing water pump impeller, how do I disconnect the shift shaft ? Thanks for any help.
  12. G

    Force 150 hp. water pump

    Doing my first water pump on a 1990 Force 150hp. just want to know if there is anything to be aware of ? Any tricks ? Thanks for any help.
  13. G

    1986 Evenrude Yachtwin

    Can someone steer me to a diagram of the cooling system for a 1986 6 hp. Evenrude Yachtwin ser.# 329909 Mod #E6SLCDE ? Thanks.
  14. G

    Bravo one verses Bravo two drives

    Are these two drives interchangeable? Any advantages of one over the other ? Thanks
  15. G

    8hp. Yamaha

    I am trying to find out what year my Yamaha is, the numbers are 8FS== 6G1== S==038228. Can anyone tell what year it is ? Thanks !
  16. G

    Trim sender

    Hello all; Here's my question; The trim sender on my 1997 Mercruiser Bravo II drive is not working, the gauge is pegged all the way up and does not move when I move the drive up and down .Everything worked fine before winter lay up. Is there a way to test the sender and or gauge to see what...
  17. G

    Timming chain cover seal

    I have a 1997 5.7 L 350 cu. Bravo II LX . The crankshaft seal on the timing chain cover is leaking a slight bit . Does this cover need to be removed to change this seal ? I was hoping this seal goes in from the outside of the cover. Am I lucky ? Thanks
  18. G

    what Evenrude ?

    I just acquired an older Evenrude Yachtwin 6hp. Ser #329909 . Can someone tell me what year this is ? I would like to order a manual for it. I tried iBoats but, the don't recognize the Ser .number. Yhanks.
  19. G

    What distance

    What is the distance from Cape May New Jersey to Bear Inlet North Carolina by boat ? Thanks
  20. G

    Bravo II Drive

    Anyone come up wiyh a home made hoist / tripod for installing and removing a Bravo II drive. If so care to share ? Thanks
Top