Search results

  1. dlowdog9

    Best way to fix this hull damage

    Ran into the ramp (not in the best shape) when a gust of wind picked up and i hit pretty hard. What is the best way to patch/seal this? Is their colored type fillers? Thanks for any input!! 2004 Sea Ray 185 Sport
  2. dlowdog9

    Shift Shaft Bushing Replacement A1 G2

    Thanks for the responses! Job went smooth and the drive is holding pressure now!!
  3. dlowdog9

    Shift Shaft Bushing Replacement A1 G2

    I pressure tested my outdrive due to finding a little bit of water in the oil when i drained it. The seal at the shift shaft bushing by the speedo cable hookup is where the air is leaking from. I have a new bushing assembly and plan on replacing it and the impeller while i have it off. My...
  4. dlowdog9

    Am I screwed??? Alpha 1 G2 question (video)

    The slop is all the way around. I am the 3rd or 4th owner. Bought the boat 3 years ago with less than 70hrs on it. Boat sat for most of its life. I highly doubt the OD was ever changed or removed until i did it last year to install the new sensors. Im going to double check the old pins with the...
  5. dlowdog9

    Am I screwed??? Alpha 1 G2 question (video)

    I do have a zerks on the side. Drive #0W539767
  6. dlowdog9

    Am I screwed??? Alpha 1 G2 question (video)

    The item # i bought was #5. Mabey i needed the other one with the bushing?
  7. dlowdog9

    Am I screwed??? Alpha 1 G2 question (video)

    I replaced my trim sender and limit sensors last year (broken wire at sensor). While I had the outdrive off, i also replaced the hinge pins with new ones. Today, I noticed my trim limit wasnt working. When i got the boat back to storage, i removed the sensor to investigate, and the sensor fell...
  8. dlowdog9

    Sterndrive Hinge Pins Question

    Thanks, i just brushed it out with an old gun cleaning brush and hit it with brake cleaner. Used red loctite
  9. dlowdog9

    Sterndrive Hinge Pins Question

    A few weeks ago I had a trim sender wire break on me. I did my research and bought a new set of sensors and pulled the drive to do the change the way the manual says. The bushings for the trim rams were shot and the hinge pins are a twist from stripping, so i ordered new parts before putting it...
View older results
Top