Search results

  1. Walker2

    Chrysler Canopy

    I'll hook a chain to it! lol Thanks much
  2. Walker2

    Chrysler Canopy

    Thank you, Matt167! That's where I'll go =]
  3. Walker2

    Chrysler Canopy

    I have a Chrysler 231. Just finished restoring. I'm sure this is a long shot but looking for a canopy for it, similar to the one in this photo. (sorry if this is your image). Any ideas where I might find such a thing?
  4. Walker2

    transom replacement Chrysler

    Thanks, Alldodge!!
  5. Walker2

    transom replacement Chrysler

    Zool, Big thanks =] So I was looking at csm and can only find in 3 oz or 1.5 oz. I assume you're referring to another type cloth?
  6. Walker2

    transom replacement Chrysler

    Replacing transom on '78 Chrysler Courier. I install epoxy floors for a living but dont know what epoxy to use for this application. I use Thixo or (cabosil) for a thickener. can I use that? Also what's the best fiberglass cloth to use over the back? TIA
  7. Walker2

    Tips and tools for rebuild powerhead

    I'll be rebuilding my 1979 Chrysler 115 outboard. I'm going to pick up some tools like torque wrenches, ring compressor etc. Looking for tips like "what not to forget to pick up" or" this would be a good sealer to use" I'm working a good distance from civilization. Any tips would be...
  8. Walker2

    Head gasket replacement

    1979 115hp Chrysler. Is there no gasket between head and head cover? Do I use RTV?
  9. Walker2

    compression test

    Chrysler 115. Third cylinder down had spark but no fuel. Performed compression test. From top down 105-65-10-105...Rebuild?
  10. Walker2

    One cylinder

    Chrysler 115 outboard. One cylinder not "working". clean plug stays clean and dry. Has spark. Assuming not getting fuel...valves? new to boat motors but have built a car engine or two.
  11. Walker2

    What is a timer / base?...Trigger

    What is a timer / base?...Trigger =]
  12. Walker2

    Idles with throttle fwd

    I have a '79 Chrysler 115 Model 1159H9C. It idles ok around 800RPM but only with throttle somewhat forward. Idle screw about 3/4 inch away from resting place on block. throttle cam rolled a bit forward. Needless to say I can't put it in gear without killing the motor. I have timed it at 32...
  13. Walker2

    Chrysler questions Which Points to buy

    Want to replace ignition points on my '79 Chrysler 115 outboard Model 1159H9C Clymer's shop manual doesn't list the part. Which points do I buy? Thanks
  14. Walker2

    tilt / trim fuse and switch

    I have a mid 70s chrysler 115 outboard. There's just green wire, blue wire, hot and ground. I think I should put in-line fuse at hot. If so what, amperage? 2nd question: Also needs new dash switch. what should the switch be rated at for amperage again? Thanks for any help on this
View older results
Top