Search results

  1. A

    Fuel filter location on 1989 sea nymph 195 gls?

    Thanks for any tips
  2. A

    1988 88 special sitting for 3 years. Needs choke to run. Help please

    Loking at a 1988. 88 special ...was setting for years...... Compression 4x95 Spark 4x Took coaxing but started with key pushed in....longer I held the rpms grew faster. Soon responded to throttle control. Fast slow........not real well but responded but still needed key presssed or engine...
  3. A

    Power trim fluid for 1988 70hp 3 ram system?

    one big center ram...two smaller bottom "pistons" Fluid appears red. What to use? How much to fill? My trim is stuck ....i think its the motor, i dont hear anyting humming but the motor is drawing current cause the wires spark when i connect jumper cables direaclyt to the green plus and...
  4. A

    Aluminum boat paint restoration chalking faded

    Anybody have experience with paint restoration on older aluminum hulls? Polishing compound? Any other chemicals? Recommended waxes? Thanks for any advice BOat has not been in water for 3 years... Setting outside in sun
  5. A

    1996 Starcraft super fisherman 19. Needs carpet pleae help

    Does the floor come up in sections? Any tips on recarpeting? I dread the thought of tearing boat apart Appleo
  6. A

    1998 starcraft super fisherman wood floor help

    Does this floor come up in sections? I need to replace carpet. Thanks. Appleo
  7. A

    Help. Seeking wiring diagram 1985 50hp mercury 4 cylinders thank you

    Please attach a diagram file if you have one thank you my motor won't spark
  8. A

    Help! 1985 Mercury 50 hp 4 cylinder stator resistance? 398-5454A21

    Helping a friend fix his merc no spark His "repair shop" suggested a new stator Wires look clean to me I pulled the stator and found no broken leads or rotted insulation Anybody have the resitance measurements or how i can check stator? I personally believe it is the ignition control...
  9. A

    Mercury 3 cyl 1977 era 70hp firing order wiring ignition module-coils-plugs

    can anyone refresh me on the firing order/hookup of the ingition module output? right now i have module top output wire/stud to top coil to top cylinder middle moduel output/stud to middle coil to middle cylinder bottom module output/stud to...
  10. A

    Mercury 70hp 3cyl 1977 one coil not firing

    Top number 1 coil no spark. Checked everything Finally tried number CID number 2 trigger wire into number 1 coil Number 1 coil now Sparks good So is CID box bad. Or could it be something else?
  11. A

    mercury 70hp 1988 Power trim help

    Bought used motor Trim stuck in UP positon 1 big ram plus 2 bottom rams i found blue green black wires to trim pump direct Battery jumpered green plus black neg no reply Battery jumpered blue plus back neg no reply yes i have the mechanical tilt lock relaxed loosened relief plastic screw ...
  12. A

    1988 merc 90hp fouls plugs help

    Boat has a 90hp Mercury that runs when it wants to. I have had the carbs rebuilt, all new fuel lines with water separator, coils, plugs but still likes to foul out plugs. any ideas?
  13. A

    Need advice flywheel nut removal merc 50hp outboard

    How do I hold the flywheel stationary while I remove the nut? Is the thread a normal right tighty?
  14. A

    Need recommendation for glue to hold carpet to aluminum rails and interior surfaces

    What have you looks found to work and be durable? Wonder what the factory used?
  15. A

    Respirator needed with Enamel paint hardener???????

    Obvioulsy if you are spraying...... But what about just brushing or rolling on my aluminum hull?
  16. A

    Help -simple question 2003 merury 40hp 2cyl, 1carb, 2stroke....where is idle mix

    Can't find idle mix screw..in my manul or on carb......please help Appleo
  17. A

    Riveted Aluminum Hull - Keel repair needed/cracked up front. - need advice

    17 foot starcract...keel has crack.....need advce on repair option. Thanks Danny
  18. A

    Hull cleaner recommendation needed. for white and painted sections Fiberglass

    Please send recommedations of cleaners and process used if you had this boat Thannks appleo
  19. A

    Transom clamps on 1986 70hp 3cylinder NOT?

    Picked up used 70hp with trim tilt The transom mount doesn't have the hook style transom clamps with big tightening bolts. It has just a tiny hook on the upper edge of the mounting brackets..not enough to really hang the motor with Appears the prior owner had the motor attached with 4 large...
  20. A

    Help Please! Need Fiberglass repair assessment

    Happy easter! IM looking a a boat purchase over easter holiday. hull and floor and transom appear stong this boat however appered to have a collision and a fiberglass patch on the side not large however likley at the water line. 2nd owner see the attched pics and you can see the...
Top