Search results

  1. R

    4.5 mercury 2 stroke

    5 HP motors are used on 25" and 3000 LB sailboats to get in and out of the harbor.
  2. R

    Evinrude 50 rundown help

    Mix gas and oil at 50:1 on it.-----Operate bulb on hose till firm.----Raise fast idle lever.----Push key in and hold it in while cranking the motor over.-----Push key in as needed till motor warms a bit.----Do not let motor rev wildly in neutral.----Install a new water pump impeller and test the...
  3. R

    2000 70hp Evinrude 4 stroke. Thoughts

    Did you get an alarm on this Suzuki motor ?------Check lower unit oil.-----Check engine oil level ?----Did motor hit a submerged object ?
  4. R

    Engine building tip regarding gel-seal?

    Bolts will torque up.----Does not matter if anything is in the way !
  5. R

    Engine building tip regarding gel-seal?

    Absolutely no sealer to be used on upper and lower bearing housings !!
  6. R

    Buzzing in throttle housing '84 Johnson 90HP 4 cyl

    In 1970 they had the tiny red warning light on top of the control box.----Nobody can look at the control box all day.----In 1971 they installed the horn.
  7. R

    2004 Johnson 50hp buying advice

    Ignition parts is the least of worry.----Those gearcases are NOT robust in my opinion.----Ask seller about gearcase maintenance history.----Do a compression test.
  8. R

    Force 120hp won't start

    If the flywheel key is sheard the timing will be wrong.-----
  9. R

    Force 120hp won't start

    Pushing the key ( sluetel ) in and holding it in while cranking it over to start ?----Check the flywheel key too.
  10. R

    Evinrude 55 HP Running On 1 Cylinder

    No guessing or your part.---Best to check the fuel pump diaphragm !!
  11. R

    Water pump not pumping enough water

    Repeat.----Water needs to be 8" above the impeller.----Get a bigger bucket.
  12. R

    Water pump not pumping enough water

    I have never had to test a water pump with a drill in over 50 years.----When you are test running the motor is water 8" above the impeller ?
  13. R

    I REALLY need input on a (just purchased, no history) OMC TurboJet 115 Initial startup and troubleshooting attempt.

    Make sure the carburetor high speed jets are clean.-----They are inside the carburetor bowls.
  14. R

    Evinrude 55 HP Running On 1 Cylinder

    Check the fuel pump diaphragm.
  15. R

    Water pump not pumping enough water

    Is water 8" above the impeller in your test bucket , yes or no?
  16. R

    Need help to id the motor

    I would not want that example of a motor on my boat !!
  17. R

    Need help to id the motor

    Given the thermostat location it is between a 1987 and a 1992 model.-----But I think that mess of a corroded motor needs a complete teardown and inspection.----It might even be hard to get all the bolts out.
  18. R

    Water pump not pumping enough water

    Did you use factory ( quality ) parts ?-----Is the motor overheating ?----Inspected / tested the thermostat ?
  19. R

    93 Johnson Distress Call

    Sometimes folks do not have the time to do it right the first time.-----But always find the time ( money ) to do it over again.
  20. R

    OMC Tiller motors

    I am sure there are some E-TEC tiller kits on the shelf somewhere.-----See one for 60,70 ,90 HP listed at only $1411.49
Top