Search results

  1. C

    2005 175 Evinrudes

    sent you PM on FICHT info
  2. C

    1979 35hp Johnson - smallest battery?

    lots of variables here... current draw needs of the starter how good does the engine start does it start good with the spare pull cord in case that smaller battery goes RIP to big is better than to small .... bring a set of oars :) and PFD ... a 35hp on a 12 footer and you :-(...
  3. C

    1957 Johnson 18 hp. FDE-11

    does the tank go psssst if you pop open the cap when theengine is running ? NO ??? possible flaw in the the 2 small check valves behind the carb plate used to build up pressure in the tank. motor obviously not self feeding itself or the fuel needs help to find it's way back into the...
  4. C

    70 hp Johnson wont accelerate

    yep wrong list range" :-(
  5. C

    1989 Evinrude 25 hp wiring help

    you need a post for starting/selenoid ....
  6. C

    70 hp Johnson wont accelerate

    seems they only made them from 1974 to 1979 what is your mdl # ??
  7. C

    70 hp Johnson wont accelerate

    mdl # year manuf ? hitting the choke fed it some extra fuel so it looks like fuel starvation venting OK on te thank .... no air leaks tank to carb ? looks like old style carbs... how good did you clean the HS jet behind that lower bolt on the carbs
  8. C

    1989 Evinrude 25 hp wiring help

    found the A post ???
  9. C

    evinrude 50 overheat alarm

    topic is 14 years old !!! best to start a new topic
  10. C

    1986 Johnson 40hp short circuit

    rectifier could have fried...engine may run but won't charge anymore. it is not a regulator so a $10 3 phase full wave rectifier should do the job...
  11. C

    2005 175 Evinrudes

    True... !!! good eye the serial starts with F .... yet same basic technology concept similar fault codes and all. ETEC board will not be answering questions on FICHT but the search utility may be usefull to some extent . the same EV diag works on both ETECs and FICHT...
  12. C

    35 hp johnson loses power at high rpm.

    tank venting ok ?
  13. C

    1989 Evinrude 25 hp wiring help

    switch designs can vary so you need to physically establish the switching desing pattern and connect proper wires to each screw post. sorry can't do much more at this end.
  14. C

    1989 Evinrude 25 hp wiring help

    one wire is CHOKE so touch 12v on it to hear the choke pull up One wire is Start/selenoid so touch 12v on it to hear the starter going accessories connect to the A post FROM A with a ohm meter find the B+ post which is the ONLY one connected to A with the key at the ON position see...
  15. C

    1989 Evinrude 25 hp wiring help

    do you not see letter A pointed to by the left arrow ???
  16. C

    2005 175 Evinrudes

    Check PM's .....
  17. C

    2005 175 Evinrudes

    btw did your check the EMM lights themselves ?? are any ON while the engine runs...poorly At Key ON all lights should light up and then go off do you see any remaining ON at KEY ON ??? (EV diag. should have flagged those) if no faults pop on EV diag, no lights come on the TACH or...
  18. C

    2005 175 Evinrudes

    see list
  19. C

    2005 175 Evinrudes

    you may want to post on the ETEC owners board where ETEC owners and experienced service folks can pitch in. no offense to anyone. The site has a good search utility also :-) https://www.etecownersgroup.com/?forum=136485
  20. C

    1989 Evinrude 25 hp wiring help

    https://continuouswave.com/whaler/reference/electricStart.html https://continuouswave.com/whaler/reference/ignitionSwitch.html more info
Top