Search results

  1. Grub54891

    Electric Boats

    California's electrical grid is shot. Texas isn't far behind. Look at what happend to Texas when they had one cold snap. The entire grid went down. Fix the grid, spend millions for that, figure out how to make power before selling things that require more power. How about going back to horse and...
  2. Grub54891

    3.0 litre Mercruiser sterndrive oil issue

    I was just going to say this. I've had good luck with the square ones.
  3. Grub54891

    3.0 litre Mercruiser sterndrive oil issue

    I was just thinking the same thing. Even a good filter can blow the gasket if tightend incorrectly, or double gasket.
  4. Grub54891

    Electrical issue

    Just run a jumper across the breaker** only for testing! ** If things work, then it's the breaker.
  5. Grub54891

    Ho many batteries do I need?

    Get the bigger charger. Even if you don't need it right away, you will have it when you do.
  6. Grub54891

    Happiest Day of Ownership !!!

    Sometimes they are under the motor. And some have another in the v-berth.
  7. Grub54891

    Freezer meat

    nice, its been 5 years since I was done 15 min after opening and got my 8 pointer!.
  8. Grub54891

    Advice on trimming out this door

    Cut your trim out at an angle to taper it back to the wall till you finish up the rest.
  9. Grub54891

    Help - Lund 2025 Pro-V Battery Removal

    Till you figure it out, just put them back in place, Make sure hey are fully charged, disconnect the neg battery posts and go to bed. If they are shot in the spring, they didn't want to be batteries anymore anyway. I always do this method and get 6 years out them or so. Sometimes a bit more...
  10. Grub54891

    Towing Boat In Cold Temperature

    Fertherest thing from my mind would be the hull itself. more worried about anything winterized properly.
  11. Grub54891

    Happiest Day of Ownership !!!

    Nice ride! I see you will have to clean the garage, put in a bigger/taller door, and remodel the house to fit!
  12. Grub54891

    Engine Mount Trolling Motors

    I've been running 50/1 in all my stuff for all my life. Haven't had an issue.
  13. Grub54891

    Engine Mount Trolling Motors

    Whatever you do, remove the trolling motor from the main motor if you bring it to the shop for service please. I've serviced lots of boats with different setups, and it adds hours to a service order as we have to remove all the junk attached to do an impeller and stuff. Saves ya money to remove...
  14. Grub54891

    Slide hammer puller

    Yeah, I misread the post. The carrier does come out without damaging the bearings. Spray plenty of knocker loose in there to help loosen corrosion. I've had two over the years that broke removing them. Did several hundred of them though. A little heat on the case don't hurt either.
  15. Grub54891

    Slide hammer puller

    Shure, but pulling/banging on the inner race damages the bearings. Are you replacing them?
  16. Grub54891

    Trim reservoir filling

    Fill it not quite full, trim up and down a few times. It's a good idea to put a rag under the trim pump area before trimming. It's because if it was real low, it will foam up and look over-filled, some may come out. You will have to let it sit overnight at that point and check again in the...
  17. Grub54891

    12v Motorguide keeps frying switches.

    Glad you found it. I was going to comment about the pic of your wiring, wick to me looks fine. Glad you found the issue.
  18. Grub54891

    12v Motorguide keeps frying switches.

    What size is the wiring from the battery to the switch/trolling motor? Undersized wiring will wreck things rather quickly.
  19. Grub54891

    Hey Newbies

    Ok, Yeah it only freezes here once a year, the problem is it stays froze for 6 months...... LOL
  20. Grub54891

    Hey Newbies

    Ok fine. There are plenty of frozen blocks e in Texas you can buy cheap!
View older results
Top