Search results

  1. Scott Danforth

    Heat Exchanger Swap

    a - was a factory upgrade. in fact, most were updated b - find the upgrade kit c - you have a 470, start reading up on the pitfalls of the motor. the heat exchanger swap is relatively easy
  2. Scott Danforth

    Electric Cars or Trucks

    but it ends in Hamster in a cast
  3. Scott Danforth

    Hey Newbies

    Nah, I just hate askholes Askhole (noun) 1) A person who always asks a lot of questions and your advice, yet never takes your advice. 2) A person who is generally annoying due to amount of questions ...
  4. Scott Danforth

    Painting fiberglass

    I would spray black gel coat with duratec 904 additive. the gel is cheap, the 904 is not. however it is still cheaper than any of the top-side paints no need for 20 quarts (5 gallons). a single gallon will spray a 26 foot boat exterior and have extra left, 2 gallons will cover the exterior...
  5. Scott Danforth

    Hey Newbies

    Hey newbies..... when you ask a question and its answered and we provide links to the stickies where all the similar topics have been addressed, AND you reply OK, or Thanks..... do not ask the same question again
  6. Scott Danforth

    Saltwater Anodes

    used to work in the yachting world where we would do calculations to determine how many dozens of these . https://www.boatzincs.com/dp-612.html or these https://www.deepblueyachtsupply.com/undrilled-bolt-plate-zinc-anodes would get bolted to the hull yes, magnesium and aluminum lasts...
  7. Scott Danforth

    1978 Chrysler floor help?

    did you read the links in the stickies? its all covered there.
  8. Scott Danforth

    Old fiberglass diagnosis

    since the floor has rotted out, the stringers and transom are gone (the floor always rots after the transom and stringers that Obsolete Motor Co (OMC) V6 is obsolete. parts are NLA for that motor, and probably the drive. the hull has lots of flex cracks. to repair, you must grind all the...
  9. Scott Danforth

    Electric Cars or Trucks

    since the MEME was not politically or children friendly summarize: GM: lets make the corvette all electric Ford: lets make the mustang a 4-door all electric Dodge: lets put the hellcat crate motor in a minivan... I may not need 707hp in a minivan, but I want one
  10. Scott Danforth

    Electric Cars or Trucks

    Slot Cars
  11. Scott Danforth

    Boat swamped, let's see if we can get it running...

    Just do not want you to have to takw things apart again
  12. Scott Danforth

    Water in oil

    Yes, water leaking into cylinders will ultimately get to the crankcase
  13. Scott Danforth

    Boat swamped, let's see if we can get it running...

    Your steering cable will get worse.
  14. Scott Danforth

    1995 Searay 5.7 GM winterizing mods..

    Fuel is the cheapest part of boating If your JB weld job doesnt work, you not only overheat the motor, you flood the bilge and sink your boat $75 in lumber, $8 in screws, $10 worth of chain, and a $20 come-a-long and you can build an A-frame and pull the motor
  15. Scott Danforth

    want to run my engine out of the boat.

    You mean the condenser on the points? It is to prevent the points from burning up. In the stickies are a tutorial on points ignition. You will want to read them
  16. Scott Danforth

    Hey Newbies

    Bob or Richard Cranium
  17. Scott Danforth

    After market fuel pumps

    The original pumps are Carter / Airtex. Cheap enough to avoid chinese knockoffs
  18. Scott Danforth

    2.3 timing belt

    The marks are on the pullies. The cover is just so you dont hurt yourself
  19. Scott Danforth

    2.00 ratio Alpha one gen 2

    Ppphhhlllbbnttttt Iron dukes are 2.5 liter / 151 cubic inch pontiac 4 cylinders ( half a 301 V8) 120hp / 2.5liter (153 cubic inch) motors are chevrolet 4-cylinders part of the inline 6 cylinder family. Not related at all to the iron duke other than similar displacements The 3.0 is a spin-off...
  20. Scott Danforth

    1995 Searay 5.7 GM winterizing mods..

    Pull the motor
View older results
Top