Search results

  1. Scott Danforth

    Best Phone App for Charts

    you can view the navionics maps for free on their website to do that. same with the USGS maps
  2. Scott Danforth

    Valve lifter reassembly SBC

    Probably not You may get away with it, however you will probably take out cam lobes. Flat tappet lifters and cams mate for life
  3. Scott Danforth

    Ohio boat trailer title???

    Call your local registration office. Ohio may not have titles, they may only have registration cards which get signed over. Your local registration office will know what you neef
  4. Scott Danforth

    Anyone use a 2017 kia Sorrento AWD/4wd high output engine?

    You are towing, your mileage may drop to single digits. In fact dont worry about mileage. I would worry about your brakes and transmission Visibility towing a pontoon boat that is 3 feet wider than your vehicle means all you see in your mirrors is the toon. Tow mirrors may help I have use...
  5. Scott Danforth

    Ohio boat trailer title???

    What does your state require?
  6. Scott Danforth

    Newly acquired 1985 Sea Ray 260 Sundancer resto - ((help))

    Either use a moisture meter, or make test drills
  7. Scott Danforth

    Valve lifter reassembly SBC

    Lifter not in a bore, and not supplied with pressurized oil should be able to have the piston pushed all the way in, expelling the oil
  8. Scott Danforth

    Newly acquired 1985 Sea Ray 260 Sundancer resto - ((help))

    Most likely the bolsters are held in with vertical screws just behind the cushions in the hull liner. Use your fingers to find the screw heads Have you checked the stringers and transom for moisture?
  9. Scott Danforth

    Anyone use a 2017 kia Sorrento AWD/4wd high output engine?

    Your 24' lowe has a dry hull weight of 2200# Add motor, fuel and gear and you are at 3200# Add trailer and you are at 4400# Add spare tire and you are at 4450# Kia Sorrento max towing is between 2000# and 5000# However any additional weight in the kia reduces towing cap Plus the kia is a...
  10. Scott Danforth

    Not going over 2 rpms

    2 rpms means it takes 30 seconds to make 1 revolution. Cranking speed is 120 to 200 rpm
  11. Scott Danforth

    Valve lifter reassembly SBC

    They get harder, but not solid
  12. Scott Danforth

    2004 CapeCraft 22' CC

    The 100 psi seams really low Weigh the boat
  13. Scott Danforth

    1988 Rogue 2420

    Carb is back down to #81 jets, and dropped the primary accelerator pump back down to 30cc Hoping to take out this weekend. Need to see why the outdrive is dropping. I think I damaged a piston seal, or a load holding check valve is stuck open
  14. Scott Danforth

    Winter storage outside

    Good point. The water pump turns with motor Never thought of it until your comment. Been spinning the prop in gear for years without thinking about it
  15. Scott Danforth

    5.7LX rebuild question

    Call SJE (i think they are under a new name now)
  16. Scott Danforth

    2004 CapeCraft 22' CC

    Is that the actual weight per a scale, or the published dry weight? If your tabs are all the way down, they may be adding too much drag Where is your trim during the holeshot? Have you checked compression on your motor Are you getting to WOT when under load, or is that in neutral?
  17. Scott Danforth

    Prop hight

    anti-cav plate even with bottom of the keel unless you have a stepped hull
  18. Scott Danforth

    Winter storage outside

    stand up-right, pull over once or twice while in gear to get the remainder of the water out the pickup
  19. Scott Danforth

    5.7LX rebuild question

    yes, a vortec 5.7 would be about 20-40hp more than your motor (induction dependent) a 6.2 will be above that (about 340hp to 360 at crank) the issue with a 6.2 in front of an alpha is that you should run a rev limiter that drops the RPM. if the boat leaves the water and returns (small boat...
Top