Search results

  1. Scott Danforth

    Condensate in manifolds?

    Condensation is a byproduct of both combustion and temp fluctuations
  2. Scott Danforth

    5 Star Marine

    These are all new kits, not NOS. Also, a bit more to cylinder seals than just orings. Wiper seals, gland seals, rod seals and piston seals.
  3. Scott Danforth

    Have a 1979 Chrysler Conqorer - where to find a original style rear seat?

    Suggest you start with your local upholstery shop
  4. Scott Danforth

    Strange starter issue.

    Clean your battery cable connections and make sure you have a fully charged battery
  5. Scott Danforth

    5 Star Marine

    Yes on the VP I can only compare the quality of the seals. I use Hercules seals in my cylinder designs. I do not know how it compares to the supplier that provided the cylinders to VP (or Merc or others)
  6. Scott Danforth

    Have a 1979 Chrysler Conqorer - where to find a original style rear seat?

    You will need to hit your local upholstery shop
  7. Scott Danforth

    Getting out of the boat

    So youre one of those damaging the ramps. The spoil piles fom power loaders has damaged most of the ramps in Manatee county. Local ramps have signs stating no power loading.
  8. Scott Danforth

    Ear plugs

    I wear ear plugs and muffs
  9. Scott Danforth

    Oil type

    15W40, 20W50
  10. Scott Danforth

    5 Star Marine

    I will be using their VP kit soon. They use Hercules seals
  11. Scott Danforth

    Best way to remove harbor scum and moss from waterline and transom?

    bleach and a scrub brush
  12. Scott Danforth

    Getting out of the boat

    my process because power loading is not only illegal, it can get you shot in certain areas launching my 26' boat by my self: in the staging area, arrange fenders, lines, install plug, pull transom straps swing around to back down ramp, disconnect lights back up until boat is just starting to...
  13. Scott Danforth

    transom rebuilding

    coosa requires fiberglass. in your case, old-timers formula (google it here on iboats) it will penetrate and seal however if you did nothing, it will be another 38 years before someone replaces it again. you wont be owning the boat.
  14. Scott Danforth

    Chips in the gel coat on hull. Is it an issue?

    mix up some gel, cabosil and mekp, spread it on with a bondo spreader
  15. Scott Danforth

    Chips in the gel coat on hull. Is it an issue?

    Yes, repair them
  16. Scott Danforth

    Getting out of the boat

    Use the dock
  17. Scott Danforth

    primer bulb

    not unless your primer bulb had holes in it
  18. Scott Danforth

    Starboard riser hotter than port on 4.3L

    so your looking at the idle relief ports..... flow will never be symmetrical same as coolant flow to the exhaust manifolds. the one that is higher (because someone is standing in the boat causing it to list) is the one that will be warmer
  19. Scott Danforth

    4.3L OMC Cobra Conversion From Points To Electronic Ignition

    pertronix instructions still call out the diodes
  20. Scott Danforth

    Tracker Tahoe 202

    you will need to pull the drive first, then you pull the motor, then you separate the bell housing and motor to get to the coupler to re-install, you install the new coupler you install the flywheel housing you install the motor you align the motor with an alignment tool (you should have one...
Top