Search results

  1. 9

    Motor cut out on me -- Johnson/Suzuki 2005 115hp 4 stroke

    Should have kept pumping the bulb until the VST was full to keep the pump from running without fuel. need to figure out what is needed to keep the Fuel in VST from boiling away
  2. 9

    Motor cut out on me -- Johnson/Suzuki 2005 115hp 4 stroke

    was the primer bulb firm or were you able to push fuel into the VST when you were priming? if no fuel in the VST the pump has nothing to pressure up the rail and the pump is cooled and lubed by the fuel being pumped. not having fuel in there is not good for the pump
  3. 9

    Motor cut out on me -- Johnson/Suzuki 2005 115hp 4 stroke

    I am surprised he did not pump the primer bulb to see if that helped when the motor would not start up. does that motor have a water cooled fuel cooler that might be restricted/plugged
  4. 9

    Suzuki DT200 rev limiter at 2000

    most outboards have a rev limiter at over the normal maximin RPM. so I would think you have an overheat, low water level, or low oil flow or level on that Zuk. gauges help a lot to identify what kind of problems shows up. and make sure you alarm system works
  5. 9

    2017 Yamaha 150 hp - 4 stroke warning alarm

    you could pull the stat and test it in a pot of water as you heat it up to make sure it is in spec. and while you are at it inspect the passages to see if there is a build up that needs to be cleaned up Rydlyme marine descaler does a good job when needed
  6. 9

    2017 Yamaha 150 hp - 4 stroke warning alarm

    what are your gauges telling you?
  7. 9

    Yamaha T50 won't exceed 3500 rpm

    what is the HP rating for the boat? Probably too small of a motor for that size boat , The reason you could not find a performance Bulletin for it with a T50
  8. 9

    Yamaha 704 binnacle remote question

    stop drinking while on the boat, maybe that will keep you from bumping into it
  9. 9

    2001 Yamaha 50hp tlrz 2 stroke with prime start system starts and dies

    any updates yet on your motor link and sync and idle timing is very important
  10. 9

    Yamaha 130 v4 prop question

    it does not make sense to me. slow to plane out to means too much prop, but that depends on if the RPM comes up fine, but prop is not biting good enough to get the boat moving fast enough. and then it over revs like there is not enough pitch or size to it did you find a boat and motor close...
  11. 9

    Yamaha 130 v4 prop question

    do a search for Yamaha performance bulletins
  12. 9

    Yamaha 130 v4 prop question

    have you looked at Yamaha performance bulletins to see if they had a motor and rig like yours to see what it showed? I thought 6K was above the max on most 2 strokes
  13. 9

    2001 Yamaha 50hp tlrz 2 stroke with prime start system starts and dies

    did you follow the link and sync procedure in your service manual after you put the carbs back on? all 3 carbs throttle plates need to completely closed and tied together so all are contributing to the idle the same. (not just set at idle position) also the timing is part of the procedure
  14. 9

    2001 Yamaha 50hp tlrz 2 stroke with prime start system starts and dies

    you have not reported what the timing is doing with the new CDI box installed. at start up my C40TLRX shows around 5 BTDC and idles high. once warmed up it drops back to 7 ATDC. what does yours show? also post up a pic of your new CDI box hooked up. I am not following the problem with the...
  15. 9

    2001 Yamaha 50hp tlrz 2 stroke with prime start system starts and dies

    there is a chance you have a leak between the pump and fuel tank allowing air to be sucked in,. But then the pump runs off of the #3 crankcase so it just pulses ,so does not run a steady stream. rereading your other post, if pumping the primer bulb helps then look for an air leak between the...
  16. 9

    Yamaha T50 won't exceed 3500 rpm

    Only T50 I found listed was on a 15'7" toon I would not be expecting much on a 20' https://yamahaoutboards.com/outboards/jet-drive-high-thrust/high-thrust/f50-(high-thrust)/pb_god_mighty-g-cruise_t50lb_8-7-2022_pnt
  17. 9

    Yamaha T50 won't exceed 3500 rpm

    a t50 pushing a 20 ft pontoon? not much motor . have you looked at what other people are pushing a boat like yours with? also what prop they used? look at yamaha performance bulitens online to see if they list a T50 for a toon like yours , and if so what prop that used.
  18. 9

    Correct Sparkplug 2000 200hp Saltwaterseries 2 stroke

    That is not the Yamaha manual. do what you want
  19. 9

    Correct Sparkplug 2000 200hp Saltwaterseries 2 stroke

    was that a Yamaha service manual or an aftermarket one? Boscoe said the Yamaha service manual and owner's manual by the way you mentioned copper ring on some plugs, copper and aluminum do not get along well touching each other
  20. 9

    130 v4 oil tank refilling point

    simple to start draining the tank slowly and see when it refills but I would think your service manual for your motor would tell you about how far it would move to set the switch
Top