FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
I am thinking he is looking for the part that connects to the 10 pin (or six pin according to pic) harness that has the bullet connections on the wires that plug into the ones on the 704
did you make sure the shift shaft lined up with the top part as you put the lower unit back on?
bottom part will not turn if they are not hooked up to each other.
it you moved the shift shaft while the lower unit was off , you will need to take it back off and make sure both in neutral or the...
check for spark and timing with a timing light and also open the drains on the carb bowls to see if they have fuel.
need good compression,good spark at the correct time, and proper fuel to air ratio in the cylinders to start and run
never heard of a motor that would not pump water out of the Tell tail when running on muffs
is this an after market kit you bought?
Never heard of a Yamaha kit including housing.
heck, even my China made meter reads OL when no continuity is there,
along with all of the other meters including Flukes.
even set to diode testing it reads OL if no connection is seen
well the manual does not give specs that low, so we have to think the low speed charge coil is bad or the wiring to it.
but if the low speed coil is not putting out what is needed, then I do not see how the other plugs would be sparking
this is getting very strange.
