Search results

I am mounting a jack plate with tilt it has 2 wires, what will i need to wire, is it possible to work without relays? any help, ideas appreciated, thanks

i have a 1973 6hp evinrude question, what should be good compression? thanks guys

housing looks good on the outside.i have never been able to put one back together once i take it apart

my trim locks up, just clicks, up or down, when i tap on the motor it works again,. is this something i can repair, or do i need to buy a new motor. this motor has set up for a long time. thanks guys

trying to bring this old motor back to life, it has very little spark, almost none at the plugs. where should i look first? thanks guys

I have removed my oil injection, do I mix 50 to 1 or 100 to 1 thanks for any info

40ETLG sorry, thanks

Is there anyplace i can find a wiring diagram for tilt and trim? thanks

it is an electric start, battery is new and spinning fast. Battery is not the problem

yes, no fire to spark plugs

you right MQ-12A it is a 25hp, 1966? thanks

i know how a outboard works. my question was trouble shoot a motor with NO fire thanks

i cannot find a year model the model is mc-12a any one? thanks

motor was running fine when i put up for winter. today it will not fire. fuse is good kill switch is connected, i do not no what to check next. any ideas or suggestions greatly appreciated. thanks guys

what would be first suspect?

motor was running fine, shut it off, then will not start, no fire at all

is there a way to check the stator not running? thanks guys

i have taken apart and cleaned. Float and valve are working perfectly. The gas goes directly to the top before the float chamber. I am going to try and seal the vent

the black plastic top has notches 2 on each side. squeez the bulb gas shoots a foot out of the notch directly above the gas inlet nipple

that is what i thought also. The float is working properly, there is a port hole connecting the fuel to the top before it gets to the float