Search results

Here is an ampacity chart. You want your fuse to blow before exceeding the ampacity of the wire if it's dead shorted. Then from there you step down again to protect the device from burning. If you have a 10 amp device you run a wire to carry 15 amps and fuse at 10 amps for the device. If your...

That's frigging hilarious 😂

Work on roller coasters and that's about all we use is American made timkins when possible

Tabbing does more than just attach itself.... So as your tabbings Get wider, the joint flexes more. Like a leaf spring pack. you want to minimize that sharp edge so when the hull flexes, it flexes gradually. Not at a sharp 90deg. If i explained that goodernuff... bed the joint however and...

Does your ride control have a dedicated fuse you can pull

Hose- dull screwdriver and channel locks . Gently work screwdriver in and around while also gently working hose back and forth with channel locks. Eventually ot will break free as you get deeper. Dash- looks worse than mine did and I had more stuff

Slow poke for sure. ...... Almost as slow as me!

We use oilite bushings alot. There is a site called selflube dot com. They have good examples and sizes

My turn to congrat

Here is my guess blacks are both negatives and colors are from senders. Put a meter on the pairs and verify. Red and black pair 1. yellow and black/yellow pair 2. If they are bulbs it shouldn't matter direction. Leds would Just guessing

5 amp load would be 12 g for 3% drop and 14 g for 10% drop at 25 feet

You could probably get away with 10 Guage cuz you would be close and it's not a motor load

Find the full load amperage of your device. Take that number and times by 125% and that's your required demand at the device. Then use this chart to Guage wire size. So let's say it draws 10 amps That would be 12.5. round up to next column would be 15 amps. Using 3%voltage drop and 25 feet of...

That is a hilarious..... I never or didnt even notice the date. The aol is my go to email address and the one my brain defaults to. I am logged out of jruka on my new device so if you wipe that whole account I will fix my preferred email after you clean up my mess Thanks

@colonel_sanders Well I got a new phone and did the same thing and have the same issue. I am banned on my new device again. Can this issue be resolved. I think what we did last time was unban jruka so I could logout of that account and log Into the right account. Then can I get this wrong...

500 watt halogen 😁

For the price of the wire feed he would need to weld that properly... be cheaper to have a fab shop do it. Could get a cheapo ac buzz box but to stick weld correctly takes a fair amount of practice .... even with 6013 rod much less 7018 I would use

Pull a sensor. Attach a meter on it set to ohms and drop in 200 deg water. If the reading changes icrmentally in a numerical value it should work on temp guage. If it switches from close to open to close it's just for a id10t light. Also note the resistance range to order the right guage if it...

When I did mine it was not foam backed. I got it with the boat so I used it. Due to the compound angles I could not see any way to put panels up. I think if I had foam backing I might have had a easier fight with wrinkles....just guessing.... And I have one small spot where wiring is touching it...

If you are in Europe from what I gather they use a non styrene based binder but in the Americas I think it's all styrene based but I would not bet real money on that. I would say to get documentation on what the binder is at least. Would suck to do all that work and have it fail. And it would...