Search results

Looks normal. Pee stream won't flow until thermostat opens. Did you make sure the washers are on the impeller? No cracks on the housing grommet

DO NOT BEND THE WATER TUBE.

75 and 79 are different motors. The 75 is a 22 CID block the 79 is a 32 CID block. Not much in common

Did the water tube come out with the lower unit?

That motor would not have normally come with a 5 in spacer for a 20" shaft. Center section would have been cast as a 20".

The ball is supposed to get hard that is normal. Do a compression and spark test. and the model #

Buy a used one off of ebay. They usually plug right in by the CDI

compression might be ok. Sounds like you are running on 1 cylinder. Check you points and coils

Should be a kill switch on the front of the motor. Red toggle

NO just you

simple solenoid on your motor. Choke should only work with the key in the on position and pressed in. Simple adjustment move the solenoid body until it works correctly, And redo your wiring.

The L shaped end goes through the hole for the timer base bracket. should be a square hole

None of that makes any sense.

Tether attached?

Definitely no long soaks

Make them. It's jus a bar with 2 bent solid rod pieces.

Thats why I asked. Are you good with that? Feelings not hurt to bad?

Did you remove the pulse limiter? VST pump working

Use the 2 metal washers and you have to have fuel resistant orings. people who had them fail used plumbing orings

The fact you can hold those 2 spark plug wires means you do not have spark on those 2. . Is there water intrusion? those motors are known for exhaust gasket leaks. Timer base connected and moving ? Get an open air spark checker. make sure spark jumps 7/16 "