Search results

Your pump was supplied originally by Carter fuel systems to GM which supplied the long block to Mercruiser Summit Racing has them for a reasonable price. Your local NAPA can also supply the proper marine fuel pump

40-50 years ago, when the motor was new and maintained, it was a good motor However 40-50 years later, with unknown maintenance and operation, who knows As posted above, get it cheap enough. Plan on putting time and money into it

Got a pic of the boats keel and the anti-vent plate. With an ELPT on a short transom, the motor is way too long for the transom

I laminated my own motor mounts from plywood. Many times stronger than dimensional lumber

Does the distributor have the crab cap?

None of the comparisons or information of how something that was new 40-50 years ago would be relevant You are buying used .....How was the drive maintained? What is the wear ring diameter,? Impeller clearance?

the tracker branded motors were only on the tracker boats. so this is a second hand motor. what is the history of this motor as AD asked, is this a new to you problem with a long-time owned motor, or a new to you motor with a problem?

Malibu towers used to be made by Gere Marie. Monster Towers are made off-shore.

dont give tower manufacturers that much credit. they are slapped-together assemblies that leave the factory with sharp edges in the drilled holes and open windows in castings for wire routing. iff and I mean iff, the tower manufacturer was any good, they may have left some weld wire in the...

hey @aspeck congrats on another circumferential loop of the sun.

get the factory manual for your drive

Got a pic? If you pulled a tow hower, you pulled a similar structure

that is an ugly color

he like twenty six year olds..... because there were twenty....

based on the pic, you should just need to take the spacer out in the foreground.

not sure on your yamaha, however on OMC, Mercruiser and Volvo, slightly raise the front of the motor slightly and REMOVE the front mount. replace the belt. many people will zip tie a replacment belt to the front mount. replace the front mount and then check alignment

Don't tie down the load on a flat bed trailer.

The buttons most likely need lube

Dad had the .22 and the 30-30 by the back slider year round The .22 was usually squirrel and rabbit. The 30-30 was for deer. I have no reason to question his story

button in the center.