Search results

For the motor, you are dealing with the 1992-1995 vintage of motor. Balance shafts, non vortec

That's literally in the middle of nowhere 1 hour from anywhere I say drive down to St Pete and hit up FGCI

The sticker was intended to last thru the 1 year warranty period.

Most likely a bent con rod from hydro lock

Where in Florida. Suggest you buy your supplies local. Lots of fiberglass supply houses down here

Sticker on top the air cleaner cover

It's your money, but ^he is right about the balance and design

That's odd about Taylor as we just got some curved roof glass for a buddy's 10 year old 48'. 2 pieces of glass, $10k.

With the drive up fully, pull the gland end hose. Then go to raise the drive. If oil comes out the open hose, your piston seals are bypassing. If no oil comes out, look at the HPU Or you can have the drive all the way down and pull the blind end hose, then lower drive

You may want to look at @sphelps restoration

Welcome aboard My guess is you have a leak. Could be bellows, could be rotten transom

Serial number the is on side of block just above starter

Happy Birthday

Easy to test if it's the ram cylinder seal or the pump load holding check valve Both cylinders are plumbed together, and act as 1 cylinder. So if one seal is leaking, they both will collapse Really easy to shear the piston seal when inserting in the barrel

Yep, remote link to the kicker Not sure I would swap to a pod. Most regret it

The J and X series are the new versions. Not better, just new variants

The J and X series are the new versions. Not better, just new variants

I would pull both motors and take them to a local engine builder. That will be the most cost effective solution

D series should be the aluminum version of the F series.

You have an AQ151 motor with an SP290a drive. The AQ151 is a motor/drive package It looks clean Make sure to grease the PDS Pull the drive and do a full drive maintenance Check the PDS shaft for play. If there is any, pull the motor and rebuild the PDS assembly with new bearings and seals...