Search results

Show is a pic of the taken apart mess you got going on. Chokes aren’t to awful hard to set up, just a tad of fine tuning sometimes depending on the weather in your area.

After three posts you can put up pictures of the area in question. Any post is fine. Let us see what you are trying to figure out. And don't fill the boat with water, very hard on the hull and trailer.

What type are you looking for? got a picture of the rail in question?

Yeah Taco has manyt varieties. Thats where I got mine for the 85 Larson.

The macarater either dumps overboard, witch is illegal in most areas, or dumps/transfers the waste to a second tank onboard.

Don’t rethread it. Get a new one. The last place you don’t need a fuel leak

It would be smart. If you have any issues electrically, the paper maps may save your life.

Shower sumps : Some have a switch, some don't. I'm thinking its just for the head itself to pump the water from the lake. Unless it's a manual pump set up.

Sure, leave it on when you are there. Listen for the pump. If it kicks in once in a while when nobody is using it, you have a leak someplace. If it doesn't it's good. Still leave it off when not at the boat.

Well there you have it. If you pull the cap when running it'll do that. stop motor. Let sit for a bit. Remove stick, wipe and check. Problem solved.

Just a silly question. Did you remove the cap to add oil when it was running?

And don't cheap out on parts. Seen it to many times when someone uses cheap wires and such. The problems get worse.

I just make sure they are charged fully in the fall then unhook the grounds and leave them in the boat. In the spring I hook them up and start the boat up. Usually get 5-6 years before replacement, but when they get that old, they still work, I just replace them for the reason they are getting...

Do not tighten the set screw to tight! Just snug it up and back it off a real tiny bit. If too loose, shifting will be impossible to adjust, to tight and the cable will bind.

I've used the new repair deal on a few, they make them for alphas also. You cut out the face of the upper ring. To me it's much easier and access is good. It comes with everything shown...

Yeah, ^^^^ that worked well for me.

Nice. I was wondering if the top rail was there. Looks like they simply added to glass top to an existing platform.

I put a small stone under the wheel to keep it from moving. A small wood wedge works to.

Yeah 80 will gouge it to deep.

Should have went to 3000.