Search results

Fur babies are the hardest family members to loose

Boat builder buy motors in advance and the motor can sit in the warehouse for years before being installed in a boat. For example, Volvo was selling 8.1 liter motors as late as 2014 and these ceased to be made by GM in late 2008. My 2002 SeaRay was a left over 2001 hull with a 1999 casting...

you sure the block is a 96. all 96 motors were assembled as vortec

50 feet

Swap to vortec heads and you can go higher

look closer zool, that is a chip of gel coming loose and retained by the caulk

I put sport tabs on my searay. Best mod ever

new update on daily driver...... Thursday, developed a rattle in the trans. thought it was typical dual mass flywheel rattle at low speed. could not find anything with borescope in the clutch area could not see anything. continued to drive. Thursday night at 6:15pm, going thru the south...

tech is wrong. choke coil is same regardless of 1-barrel, 2-barrel or 4-barrel.

ABYC standard wire colors purple is ignition purple with yellow stripe is ignition while cranking yellow with red stripe is crank signal the purple wire from the round plug goes to the coil + and to the choke. It also goes to the relay that powers the fuel pump that is piloted off the oil...

what do the journals mic to? the actual diameter is equally as important to the finish.

I would use a piston stop tool to verify you are indeed on TDC however it looks like you may need a new harmonic damper (or your piston is not at TDC) normally to replace that, there is not enough room in front to get a damper puller tool in there. the motor may need to come out.

only way to re-pitch without tearing out and re-doing is to water-jet some dirt out from under one end and jack up the other with either mud jacking, foam jacking or concrete jacking I have to re-pitch the whole pool/lanai area as the slab settled about one inch over the past 20 years and the...

propane or natural gas? Did you replace the valve assemblies? sometimes the orifice gets plugged with debris and dirt. some are removable.

welcome aboard. before FriscoBoater was on youtube, he was on iboats where he learned from members like oops and ondarvr lots of good information in the stickies at the top of every forum page. suggest starting here...

I did say 4BT, not 6BT

I suggest reading the USCG boatbuilders handbook. It will cover all the requirements of every system in a boat from fuel system to ventilation to wiring to lighting.

Nearly all of the 90s jet boat hulls are balsa cored. This gave them strength and light weight vs a solid hull Some boats today still use balsa core on decks The area you have circled on your pic looks like part of the core is exposed

There is a 16 valve 4BTAA at 250hp