Search results

  1. Rranger

    Add steering at rear of boat.

    I have a 19’ Sangster craft and often fish alone. Which creates steering problems when I’m at the back, down rigging, planerboarding ect. So I’d like some type of steering control at the back of the boat. Would also be nice sitting out from under the canopy in a rear seat on nice day. Am I...
  2. Rranger

    Battery Isolator switch and Perko switch

    Thanks Dingbat, appreciate it.
  3. Rranger

    Battery Isolator switch and Perko switch

    Sorry about first pic I posted, the one below is a better one for my present setup with out having yet installed a ACR or Battery Isolator yet. Which is my point is one better than the other? I can get a 140 amp Battery isolator for $40. Main concern is keeping starter battery charged, which I...
  4. Rranger

    Battery Isolator switch and Perko switch

    Excluding the line to the alternator.
  5. Rranger

    Battery Isolator switch and Perko switch

    If beatennto death sorry but have a perko switch installed and looking to add a battery isolator switch.1994 135hp merc outboard. Do I need an alternator protection device to prevent a power dump. If not should following this pic be my quite.?
  6. Rranger

    Smoke

    I'm not mixing the oil and gas, I meant I added oil to the oil tank and read somewhere to full can cause smoke, I did fill to the full mark.. Relying on the oil injection system to do its thing. Which is probably a whole nuther discussion, at its age keep the injection system or remove system...
  7. Rranger

    Smoke

    Bought this 1994 Mercury 125HP a few years back cheap the trim tilt didn't work unplugged a port and works great. Started it a few times never noticed any amount of smoke. Over the course of this spring added oil to the tank, poured 1/2 a can of seafoam into a 1/2 full 20 gallon fuel tank to...
  8. Rranger

    Accelerator pump rebuild.

    No ball FlyingScott got it in runs hit the lake tomorrow.
  9. Rranger

    Accelerator pump rebuild.

    Hi have to install a rebuild kit for my accelerator pump on a 1994 mercury 125hp, Is there any howto tips out there, hoping it shows up today to do.
  10. Rranger

    Old Sangstercraft.

    Thanks Scott Danforth all fixed.
  11. Rranger

    Old Sangstercraft.

    Cabin cover plastic frame connector broke. Attaches frame piece over cabin in frame above windows. I attached two pics one is good the other is broken one. Two questions is the one in the Iboats link the correct replacement? And in second pic can see I got about 1/8th of an inch to work with to...
  12. Rranger

    Motor won’t shut off.

    Teasmark I believe I found my issue ground coming off the remote plug wasn’t hooked up. Got this off a guy what else will I find lol.
  13. Rranger

    Motor won’t shut off.

    Might need this dummied down a bit for me. I’ve attached a pic of the starting circuit. If u could please identify the cd module, cdm and wh connection? And do u happen to know what the tan and tan/white stripe wires coming off the male end of the electrical 8 prong plug at motor are for?
  14. Rranger

    Motor won’t shut off.

    1996 Mercury 125hp serial OGO86789 1)motor will not shutoff with key or kill switch. Is there wires I can use jumpers on or disconnect to kill the motor. 2) one pic has a brown wire and a brown/white stripe wire off the male end of the cable from the remote plugged in at the engine. I don’t see...
  15. Rranger

    Motor won’t shut off.

    1996 Mercury 125hp serial OGO86789 1)motor will not shutoff with key or kill switch. Os there wireS I can use jumpers on to kill? 2) one pic has a brown wire and a brown/white stripe wire off the male end of the cable from the remote plugged in at the engine. I don’t see anything to plug them...
  16. Rranger

    Shifting problem

    Racerone my bad, took cowling off looked good under. Did the neutral thing and and it’s all good. Shifts. Now adjust cables and should be good. Thanks to you and Chris1956.
  17. Rranger

    Shifting problem

    My problem is the shift mechanism on the side of the powerhead is not working. It doesn’t engage slides freely back and forth. It appears the lever coming off the mechanism, that attaches under the front of the powerhead above the cowling is not connected for some reason and that’s why I can’t...
  18. Rranger

    Shifting problem

    Took apart shifted the remote cable to forward same as outdrive put back together and powerhead is not shifting at all. Remote goes back and forth with very littls resistance. So when my remote cable is off the shifter I should be able to shift on the side of the power head or not?. Right now I...
  19. Rranger

    Shifting problem

    R I was wondering that. I should add there is a Bay leg extension kit between the drive and powerhead. Maybe got wrong shift shaft extension? Will be dropping lower unit today. I should also mention shifter control was in neutral and gearcase in forward gear the last time I put it together so...
  20. Rranger

    Shifting problem

    I’m going to guess I have to pull the drive and make sure the outdrive and power head are in the same gear? And what would be the procedure to get them in the same gear.?
Top