Search results

  1. Rranger

    Fuel setup two outboards, one tank.

    I guess we find out on the lake.
  2. Rranger

    Fuel setup two outboards, one tank.

    I have run my 5/16" line from separator to my 9.9hp Honda and my 3/8" line to my Merc 125HP from separator. Both with primer bulbs. Do the primer bulbs have backflow preventors built in?
  3. Rranger

    Fuel setup two outboards, one tank.

    I probably have the answer but will ask. I have a merc 125hp and Honda 9.9 kicker coming off one fuel tank with one line into a fuel/water separator and one line out to a primer bulb then tee'd to a 5/16 line to the kicker and 3/8 line to the 115 HP. My kicker stalled a couple times last time...
  4. Rranger

    Wiring a water temp gauge.

    Goes off at cruise speed. New thermostat just installed, have a leg extension kit so took drive off and checked impellor( was new) its fine. Poppet Valve I changed the diaphragm, rest looked good. And changed installation method of the ext. kit and outdrive to make sure I have a good seal with...
  5. Rranger

    Wiring a water temp gauge.

    Chris1956 I am checking out water pressure gauge’s to buy and will probably go that way, but had a couple water temp gauges, sender was cheap so trying that to get to bottom of temp alarm going off.
  6. Rranger

    Wiring a water temp gauge.

    May have found it on net tan/white stripe goes to trim unit?
  7. Rranger

    Wiring a water temp gauge.

    A couple more questions my third pic shows a tan and a tan/white stripe wire coming off my remote cable at the engine. As they are also coming off the remote control at the front. From what I’ve read the tan wire is for my sending unit to the gauge at the helm. So I run it from the sending unit...
  8. Rranger

    Wiring a water temp gauge.

    Thanks briangcc appreciate that. Now I can remove it and put in my new sending unit. And will look around for the alarm sender.
  9. Rranger

    Wiring a water temp gauge.

  10. Rranger

    Wiring a water temp gauge.

    I don't think it overheated only that the alarm went off. Non stop alarm. Shut off motor for a bit end of alarm til it runs some more. So the plug in the engine is for the alarm? In the video below the guy takes it out without explaining what its purpose is. Plus no wires to it, how does it...
  11. Rranger

    Wiring a water temp gauge.

    I did try looking up the posted diagrams but they won’t open. My motor 1996 merc 125Hp had the heat alarm come on last couple times out. Have checked impeller all good, and replaced the thermostat. Before I hit the water again I want to get a temperature gauge hooked up. My motor presently has...
  12. Rranger

    Water

    Does that amount of water seem excessive to you and others? And that's a remove the powerhead fix?
  13. Rranger

    Water

    Here is another two videos from each side. Again water only coming out the front of drive behind mounting bracket. I will guess its normal excess water coming out when running in a barrel. Didnt see water outvof there on a hose. water. Would that be right. Reason I'm asking is temp alarm going...
  14. Rranger

    Water

    The water is only coming out the top and front of the outdrive out of a hole. The water on the side of the cowling and below is a reflection. I will get a video again this morning when neighbors are awake and post it.
  15. Rranger

    Water

    I am running off a tank if that makes a difference, have run it off a hose before without that much water coming out.
  16. Rranger

    Water

    Is this amount of water coming out the front of my 1994 mercury 125hp normal?
  17. Rranger

    Adding a Battery isolator

    Run a positive wire from battery one to battery two with the isolator in between and grounded - to battery two.
  18. Rranger

    Adding a Battery isolator

    Thanks All Dodge. Looks like I can run a separate positive wire with the Isolator in between battery 1 to 2.
  19. Rranger

    Adding a Battery isolator

    Adding a Vervor battery isolator to a wiring setup with a perko switch. I'm not sure how to wire the battery isolator in. Not much on the net. Hopefully someone on here knows. Would appreciate hearing.attached is a crude drawing of present system and the vervor wiring diagram. Second question is...
  20. Rranger

    Add steering at rear of boat.

    Should have mentioned have a 125hp merc for main and 9.9hp Honda kicker. Without an easy steer. At present I lock the kicker and steer with the big motor up front.
Top