Search results

  1. C

    Required Safety Course

    Airshot, Here in NJ, we do not get a discount (that I am aware of) for the boating safety course. However, I have seen a large difference in behavior after the boating safety course was mandated, especially in wave runner riders. Most people now drive their boats and wave runners fairly...
  2. C

    2005 Mercury 115 ELPTO No Spark

    Mark, Not that it matters much, but battery/coil ignitions often produce 20K volts. CDi was always much higher. An early aftermarket unit we installed on our 1970 Mercury claimed 600,000 volts. It took the battery voltage and stepped it up to 300V, and then sent it thru the ign coil.
  3. C

    1969 IMP "Thunder" 20 ft, Restoration

    Gee, I always liked teal for boats. I had a '67 Winner with about the same color for some time. Just my preference. I almost painted my speedboat teal, but the prep work necessary to make (a dark color) it look good was too much. I went with white, so the painting prep was manageable. I...
  4. C

    Boat Battery Questions - Cranking

    Gee, without a trolling motor, do you have any other big users for juice? If not two starting batteries is just fine. Two 24 series will work. Two 27 series is probably overkill. If you have any doubt about the condition of the batteries, do what the sailboat skippers do. Start the motor...
  5. C

    Engine cranking not catching

    Your motor is likely fuel injected, and it's systems are run by an ECU. You will need to get a service manual on it. Sometimes the ECU will turn off the fuel to the injectors, when it detects an issue. Alternatively, you may have some sort of electrical problem. You might doublecheck any...
  6. C

    Swapping to an opti

    The Optimax, depending on HP, may need an oil reservoir in the boat. They cannot run properly, due to their design, on premixed fuel, so drain your tank, and add the old fuel back in, a bit at a time. as you use the Optimax. The steering from the '94 should bolt up. The water pressure gauge...
  7. C

    1989 Mercury 200 Black Max

    The alarm buzzer is often under the dashboard. It could also be inside the control. On top of the motor is a couple of electrical devices. One is the monitor unit for the oil injection. The other is the idle stabilizer, if it had not been discarded by the PO.
  8. C

    Transom replacement.

    I replaced the transom on my speedboat from the outside. I would have liked to replace it from the inside however, I did not think the cap was strong enough to support it's own weight and would break when I removed it. Two key points when replacing the transom from the outside. Replace the...
  9. C

    Gear Lube lines plugged with bolts from previous owner

    It may well be, but he never reported a place to connect the gear lube reservoir tube, but reported the gear lube was good. It is a possibility, no?
  10. C

    Gear Lube lines plugged with bolts from previous owner

    Alpha 1 Gen I outdrives did not have gear lube reservoirs. Maybe you have one of those as a replacement for the original?
  11. C

    Leak into bilge, bellows?

    BTW- the exhaust bellows will not leak water into the boat if it has a hole or crack. It is sealed to the manifolds, which are also sealed, until above the waterline. A lot of Gen 2 drives come with an exhaust tube, rather than a bellows.
  12. C

    2005 Mercury 115 ELPTO No Spark

    In that case, you will need to keep your current motor running. Here at the NJ shore, 2 cycle OB engines and OB engines with carbs are just about gone. Between the salt water and the shortage of DIY mechanics, old motors are junked more frequently than those used on lakes, and where owners...
  13. C

    2005 Mercury 115 ELPTO No Spark

    I don't know if CDM ignitions in your era had an ECU. It may be just a trigger and carbs. Newer motors will have an ECU, when they went to direct or manifold fuel injection. I just am not sure when they were incorporated.
  14. C

    2005 Mercury 115 ELPTO No Spark

    ADI refers to alternator driven ignition. They consist of a stator, one or two switchboxes, a trigger and one coil per cylinder. They appeared in the mid 70's on 3 and 4 cylinder motors, and by late 1979 were on all larger motors. CDM ignition consists of a stator, a trigger and one coil/CDI...
  15. C

    1989 Mercury 200 Black Max

    A 1989 motor would have the oil injection system, I would think. if so you have alarms for low oil and overheat. Any idea which alarm is sounding? Check the wiring harness for bare insulation on the tan wires. Tan wires with and without traces are usually the alarm control wires.
  16. C

    2005 Mercury 115 ELPTO No Spark

    Does that motor have ADI ignition or CDM ignition? In CDI ignition, the switchbox pulses voltage to the coils to fire the spark plugs. On CDM ignition, the stator powers individual CDI units at each spark plug. Since you replaced all the likely suspects, except the trigger, you might check...
  17. C

    '19 115 Merc water in fuel

    Merc Optimax's had a spin on fuel filter on the port side. It had a water sensor.
  18. C

    Required Safety Course

    The current Boating Safety course in NJ is almost word for word the USCG safety course I took in 1967. I would therefore expect states would accept Boating Safety Certs. from other states, except of course, they don't have to.
  19. C

    Crownline gas tank

    On my '88 SeaRay, the interior frames had screws holding them. Once these were out the engine and fuel tank were easily accessible. On the other hand, my neighbors Boston Whaler outrage broke a stern eye. Unfortunately the stern eyes had been installed before the top cap was put on. There is...
  20. C

    Why would SELOC say never start the engine using the fresh water attachment.

    SELOC manuals often have catastrophic errors in them. An OEM owners manual (usually free) often has flushing instructions.
Top