Search results

  1. KCKracker

    floor glassing question

    when i took the plywood out for inspection i cut around the inside about 6" from the gunwales, so when i am ready to get the new plywood back down, do i cut that existing lip out and glass it to the gunwales again or go inside the lip and glass "to" the existing lip i left, or go over the...
  2. KCKracker

    Stringer replacement, how to tackle this?

    tryingt o plan my attack. i have a 1978 rally cruizer, seems rare? cannot find a pic of another! i have 4 stringers front to back that are 1x8 with very thin glass on the sides, and they are not one piece. they seems to be interjected by a few cross braces (?) side to side that are foam...
  3. KCKracker

    Evinrude 115 VRO swap back to pulse pump, need help!

    So i am swapping out VRO for a pulse pump, have not done one in a mighty few years. got the pulse pump, i can see where it mounts in the pic, straddling the vacuum outlet which i removed the plug for. issue- underneath the mounting area about 1" is that brass connection for a hose. I am...
  4. KCKracker

    Evinrude 115 VRO, with electric fuel pump??

    friend just bought a boat, came with a evinrude e115tlcrd, 84 i think? anyways it ran great when he bought it, then after a week of use it started having issues, and he found that someone added a electric fuel pump :confused: never seen this, is is acceptable? he said he burned gas worse than...
  5. KCKracker

    93' Evinrude 15hp, wheres my idle?

    so i am getting flustered. my 15hp LS (1993) last year went putt...putt...putt.. and trolled all day great. we didnt fish for 2 months so went and ran it outta fuel, started a tad rough but cleaned up. fast forward to summer, gassed it up, fired it up, wouldnt idle or troll for crud. cleaned...
  6. KCKracker

    1985 Johnson 140 VRO alarm issue

    trying to help a friend. he has a 85 140 VRO he was cruising, alarm went off, he checked everything and found the injection oil was low, not empty but low. he filled it and all was good, no problems the rest of the trip Next trip he takes off, runs great, when he takes the RPM?s up he hits...
  7. KCKracker

    Bravo 3 seal replacement from home?

    i have a friend with a bravo 3, . The lip on the prop shaft seal is tore behind the prop and its puking oil. is there anything special about changing this seal or can it just be popped out and a new one back in? never touched a bravo 3 so not sure.
  8. KCKracker

    what pitch prop for my boat?

    ok so i have a 470 with a soon to be sei alpha1 gen1 OD, and the boat is a 22' walk around, and its slow to get on a plane but worse slow once its on a plane, what is a good prop pitch for me? or prop period, i am not prop educated :facepalm:
  9. KCKracker

    HELP! Blown Outdrive, what will fit this?

    I have a 470 engine and 470 alpha1 gen1 OD. how do i know what outdrives will fit it? i saw an ad for one alpha1 gen1 but the shop said it wouldnt fit because its off a V8 not a 4cyl. mine has 1.8 gears if that matters?
  10. KCKracker

    Mercruiser 470 OD cable adjustment

    last year got the new 470 in and still cannot get the F/R cable adjusted properly, even tried it sitting in the water, its either too much or too little there seems to be no sweet spot for Forward and reverse at the same time. and tips? :facepalm:
  11. KCKracker

    Mercruiser 470, swap to FI, any info?

    ok dont think im nuts, i have done a few automotive carb to FI / throttle body swaps over the years, and many that were a simple bolt on stand alone system. i have done alot of searching on the net and found nothing, any info on any available or done?
  12. KCKracker

    desperatly looking for a wiring diagram-- 94 evinrude 15 hp

    Evinrude 15hp model # E15ELERE just bought it and was told its manual start only. i call BS i see a starter :D now i just need to know how to wire it up and see where the starter wire comes from it goes into the tiller handle somewhere. also, looking for a charge wire for the battery.
  13. KCKracker

    need 470 wiring / coil help

    i am in desperate need of a wiring diagram WITH one wire alternator and not a voltage regulator (it does get removed right?) also, my engine harness gets hot when the key is on, i found the coil has +12 on both posts, i thought one side was negative? even if i disconnect all wires from it...
  14. KCKracker

    Need trim tab ID help

    I have a trim tab motor thats kapoot. i have a 78 fiberform and no name on this motor at all. any ideas?
  15. KCKracker

    trying to locate wiring diagrams for trim tab system / switch.

    are they specific to the boat, motor, or neither?
  16. KCKracker

    LOOKING FOR wiring diagrams for 470 alpha 1 O/D tilt motor, and trim tabs

    i have a alpha 1 470 and need wiring diagram for the hydro pump. also trim tabs, cannot find either:confused:
  17. KCKracker

    need 470 O/D part info!

    i have a 470 outdrive. i ordered a gimble housing service kit, and it didnt come with a seal i need. above my gimbal bearing theres a water pipe that goes through the housing, and its sealed with a conical/cone shaped seal. anyone know the part number or even the name? dumb local parts guy...
  18. KCKracker

    Help! I need help on 470 outdrive !!

    i want to order a kit to change seals , bellows etc in my gimbal housing but parts store has no clue what kit i need. the parts store says it will be decided which kit depending on seal size, then he said it depending ONLY on what my motor is :facepalm: . website says it depends on if i have a...
  19. KCKracker

    470 engine coupler & exhaust shutter,, bad or not?

    im swapping motors, how do i know if my rear coupler is bad or not? also my shutter flapper, is this supposed to sit tight up ahainst the pipe? mine kinda flops around
  20. KCKracker

    boat shop manuals or owners manual?

    I have never known if boats have shop manuals like cars do? I know there are engine manuals but what about for that specific boat? i searched only and google had zero results conf: looking for one for a late 76-79 era fiberform (trophy walk around style) if they make them, where would i find...
Top