Search results

  1. D

    Safe to run twin cable steering w/ one cable?

    I purchased an old neglected boat, and one of the cables on the twin cable rack and pinion system was siezed. When I removed that rack from the steering column the motor turns great...very smooth. <br />I plan to replace the steering, but that will require lifting the motor to clear the...
  2. D

    Broken Thermostat a problem?

    I pulled the thermostats on my motor and noticed that one had actually "sprung" I guess you could say...the post had actually popped to the side of the cross bar so it could no longer close. <br />I guess this would be like having no thermostat at all.<br />I'm replacing them anyway, but other...
  3. D

    Thermostat Gaskets or No Gaskets???

    I purchased replacement thermostats for my Mariner 150 (V6). I asked at the parts counter if there were any gaskets and they said no. Low an behold when I pulled the old ones out, they had rubber gaskets on them that fit around both the top and botom faces (a single piece).<br />Should I stetch...
  4. D

    Prop shaft size for MotorGuide?

    I can't seem to locate replacement nuts for the prop shaft for my Motorguide troller. What size is the shaft, and could I just use a stainless steel or nylon nut from the hardware store with a lock washer?
  5. D

    Extra items to get before pulling a L/U

    OK, I bought the water pump rebuild kit and L/U lube for my motor. I have my spare rags and tools (12 footer's post entitled "Lower units 101" was a big help).<br />But before I start this, I thought I would get a few tips from the pros on additional items I should have on hand before getting...
  6. D

    Parts in Water Pump rebuild kit

    I purchased a waterpump rebuild kit for my 150 Mariner (part# 46-96148A 8) and asked if the new seals for the Vent & Fill plugs were included. The kid behind the parts counter looked in the box and said "Ahhhh... I thinks these are them?" Not exactly instilling a lot of confidence in his...
  7. D

    Source for parts online

    Can anyone recommend a source of repair parts for a Mariner outboard (water pump impeller, fuel lines, etc...)<br />Thanks in advance
  8. D

    Newbie question.. cooling system

    I have a 150 Mariner that had been sitting for a number of years without being started. Even with my severe lack of mechanical ability I managed to follow the directions of the forum (thanks to everyone who replied) and get it running.. WOO HOO!!!<br />Unfortunatley, have no water coming out the...
  9. D

    Need a Mariner mechanic in PA, MD or DE

    I'm working on a 150 Mariner (1985ish) that has been sitting for a number of years without running. I will soon be at the extent of my mechanical ability...I'm what some refer to as mechanically declined!!! :D <br />I'm not ready to give up yet, but when the time comes, does anyone know of a...
  10. D

    Does 2 cycle oil go bad?

    I'm working on an engine that hasn't been started in a few years. <br />I've changed the gas, cleaned the filters and carbs, checked the low unit oil, changed the plugs, and have a pair of muffs to run the water through the engine.<br />I was wondering though, this engine is equipped with an oil...
  11. D

    Starting an engine after LONG storage

    I recently inherited a boat with a 1986 150hp Mariner outboard. Evidently this engine has not been started in aproximately 4 years. <br />Does anybody have a checklist of "to do's" to get this engine up and running?<br />What tasks can a basic hack machanic (me) do, and what should I have a real...
View older results
Top