Search results

  1. R

    no throttle in neutral... Mercury GEN II Concealed Side Mt Conrol 883710A02

    for some reason I cant put the shifter in neutral and give it gas.. do you have to pull ****er out to throttle in neutral? I cant go forward or reverse unless i pull the red button on the handle and it goes into gear:mad: some help would be greatly appreciated.. I have not seen too many of...
  2. R

    oil tank hook up.. 1999 200hp carbed merc

    On the remote oil tank there are 2 hoses.1 is a little higher on the cap then the other one. Does it matter which hose goes to the T off the oil tank on the motor and the nipple going to the block? If so which goes where? Thanks in advance:D
  3. R

    will 90hp force LU fit 50hp force?

    90hp is a 1992 and the 50hp is a 1996.. thanks
  4. R

    will 90hp force LU fit 50hp force?

    I have a 1996 force 50hp and someone has a 1992 90hp force LU for sale and says it will fit but I want to double check before I get it.. Thanks
  5. R

    2000 optimax smartcraft hookup question..

    200xlop I was told this model is smartcraft compatible but I can not find the smartcraft harness. Is there a conversion kit or am I just not finding it? I only have an 8 wire connector available.. Nothing with black red purple blue and white..
  6. R

    2003 mercury 25hp 2stroke choke wire hookup question

    I have a 25el 02 and I am hooking up wires. I have everything figured out except the choke. I see a black wire and a black and yellow above the carb that looks like are for the electric choke. Do I run a ground from the black wire to the block and the black and yellow to the choke ignition lead...
  7. R

    2001 optimax 200hp wont start.. only clicks

    I turn the ignition and I only hear a click maybe from starter. I bypassed the solenoid and it turns over. I used 2 different ignitions with 2 different main wire harness. Same thing .. I cleaned all battery connections and charged battery fully. 1 more thing is I dont have gas ,gauges or oil...
  8. R

    04 evinrude 135hp. metal shavings and low compression..

    I am looking at buying a motor. e135fplsrm 2004 evinrude 135hp.. I checked the compression and it was even but all were around 75lbs.. I know alot of the older motors always had low even compression but I am not sure an 04 with low hours should.. Second thing is there are small metal shavings...
  9. R

    what pitch prop to use?

    I have a 2001 200hp optimax on a 23' wa.. what would be a good pitch. The motor is a cr and I found a good deal on a 23p laser II and was wondering if this would do? I am having a hard time finding a cr prop at a reasonable price. thanks
  10. R

    2000 johnson 70hp spark and gas but no power

    j70plssd top cylinder has spark and compression but no power. when motor is running and I pull each plug wire the motor runs really rough on the 2 lower but the upper does not make a difference. When I turn the fuel mixture screw on the carb it does not bog down like the other 2 carbs. I swapped...
  11. R

    2000 johnson 70hp low rpms

    I have very low rpms but I think I narrowed down the problem..I have spark and even compression but when I remove spark plug wire from top plug while running nothing happens. The lower 2 plugs when pulled causes the motor to run very rough. another thing is the lower 2 spark plugs are fouled and...
  12. R

    which midsection will fit 95 black max v6

    I have a 95 blackmax 150hp with a rusted steering arm. Rather than replacing the steering arm I am just going to buy a mid but I am not sure what years will interchange. Thanks in advance
  13. R

    1999 sx150txrx alarm and surging

    I was out the other day with twin 99 sx150txrx and the alarm went off. I slowed down and looked at gauges but oil was fine and not overheating. 2 remote tanks were full and the 2 on the motor were full.Turned off port engine and alarm went off. I was already in the inlet heading in so I did not...
  14. R

    01 yamaha 150hp low rpms

    I just picked up a 2001 yamaha 2 stroke txrz.. The previous owner said they were riding and it was fine then they turned the motor on to head in and they could only run just under 3000 rpms. The oil level was good and no low oil on tach..The motor still had a good flow of water from the pee...
  15. R

    2000 johnson 70hp wont idle or shift on the water

    2000 johnson 70hp 2 stroke..runs and idles fine on a hose but when I take it to the ramp it spits and stalls unless I give it gas in neutral..I turned the idle up but when I shift into gear it stalls out.. I just bought the boat and changed the plugs,thermostat,impeller,fuel lines,primer...
  16. R

    2000 johnson 70hp oil injection test?

    how can you test to make sure the oil injection is working properly.. it is a 2 stroke..I just bought the boat and would like to make sure before I run it.. Thanks
  17. R

    what is this worth.. 2000 40 hp johnson

    I am going to look at this motor in the morning but I have been trying to find comps to get an idea what it is worth.. Considering good compression.. It looks to be in good shape and comes with controls and oilk tank.. I have had no luck with comps and nada says around $800. Sounds a little low...
View older results
Top