Search results

  1. C

    options for boat cover supports

    My cover fits good but it continually catches water when it's a heavy rain. it's a black cover the the supports that hold the cover up front and back were pvc and under the black cover it gets so hot the pvc bends. I found a good replacement for those. 48"x84" for the front and 48"x96" for the...
  2. C

    Going straight at low speed?

    What's the best Trim for low speed to go straight, My 18" bow rider won't go on a line without sawing the wheel back and forth?
  3. C

    My Skag got worn down, I had a power failure

    I had to drag it out of the water without trimming it up. What affect will this have on driving the boat. In your opinion Is it it bad enough to have to get it replaced. The wire came off the starter fuse at the starter.
  4. C

    Please be safe and don't forget to use your venting blower when fueling.

  5. C

    3.0 lost all power!

    FYI, if you ever lose all power suddenly, check the wires at the starter. There are 2 number 8 or number 10 wires that go into a single connector. The thin blade on that connector broke off at the lug on the starter terminal, Total sudden loss of power. 2004 3.0 merc with I/O unit.
  6. C

    wear your kill lanyard

  7. C

    Bow runner Garmin install

    I used a nylon cutting board and sacrificed the place the cup holder location on the dash. it's right in front of the gas gauge but I can still see it. https://pbs.twimg.com/media/GWf2QG7W8AAXnqX?format=jpg&name=4096x4096 https://pbs.twimg.com/media/GWf2QHAXkAAVvwP?format=jpg&name=4096x4096
  8. C

    looking for a place to install pole holders on my bow runner.

    One of the only flat places I have is on the swim platform. The gunwales are curved. I have cup holders I may be able to convert. Other ideas?
  9. C

    How hot is too hot for a boat with a black boat cover in the Sun.

    Am I damaging my boat when it gets about 140f or over with the black cover on in the Fl. Sun?
  10. C

    Grease zerk in center of the axle stripped out,

    The 1/16 thread zerk hole in the axle is stripped out, I bought a press in Zerk and tool and it's too loose to stay in. Ideas?
  11. C

    Changing manifold on a 2004 3.0.

    The drain line on my exhaust is plugged. I removed the manifold and have ordered a new one. The line I think is a bypass line that runs from the coldwater supply line coming through the transom from the impeller to the t is where the manifold drain is looks like it pumps cold water into the...
  12. C

    2004 3.0 Exhaust flapper question

    My hole where it sits is round, I ordered a 18-2727 or a 60923. the flapper with 60923 molded into it is oval, I need a round one, it shows both for the same number. is it needed?
Top