Search results

  1. S

    1980 j25rcsa solenoid issue

    Multimeter on continuity when i got the 002 and 003, tested the button same way
  2. S

    1980 j25rcsa solenoid issue

  3. S

    1980 j25rcsa solenoid issue

    A 1 when i test the 1/2 inch studs on the noid..
  4. S

    1980 j25rcsa solenoid issue

    I get 002 or 003 on the 3/8 posts and a 1 on the left side of screen on multimeter....im getting 14 volts when i test the post that the batt. Connects to on solenoid and use ground on block...it was hooked up like the diagram and all was well....same now but not all is well haha....hmmmmm
  5. S

    1980 j25rcsa solenoid issue

    And i put a new solenoid on it and now it dont even click...
  6. S

    1980 j25rcsa solenoid issue

    Safetey switch post...got it, i will try that
  7. S

    1980 j25rcsa solenoid issue

    It clicks...if i touch jumper cable to the solenoid post between the starter and solenoid it turns the starter but nothing with the button...14.4 volts on batt.
  8. S

    1980 j25rcsa solenoid issue

    You mean run a ground between the solenoid and the block off wich small post?
  9. S

    1980 j25rcsa solenoid issue

    Heres a diagram of how it was and is now hooked up, now the solenoid just clicks when i push start button? Am i missing something??
  10. S

    Auto oiler

    Wise move......
  11. S

    Flywheel material?

    Why not buy the right flywheel???
  12. S

    Compresion gt 200

    100 or over id assume is good...
  13. S

    Compresion gt 200

    Ive tried to find those numbers for any year or model evinrude johnson for years and have came up with nothing.....good luck!
  14. S

    New 1993 Evinrude 48spl

    X2
  15. S

    Whats good???

    Take your word for it....honestly id rather have a pre 90's omc over any new 2 or 4 stroke.....RELIABILITY! with very minimal maintnance....
  16. S

    Whats good???

    Why do you say that?
  17. S

    Whats good???

    Thats dry...no fuel hooked up and just put crank and powerhead back together...tiny bit of 2 stroke oil used when putting pistons back in cylinders a cpl days ago...
  18. S

    Whats good???

    125 top and the width of the needle on my guage below 125 on the bottom...
  19. S

    Need quick help: The Tilt Support Bar on my Etec wont move after tilting engine up, due out tomorrow!

    Year and model will help...
  20. S

    Whats good???

    What would be considered good compression on an 1980 johnson 25hp? Anyone know what the compression is from the factory new??
Top