Search results

  1. frustratedboater

    2010 Suzuki DF225TXX Chart Help

    Good evening, I had posted some questions regarding a cracked pinion gear and have decided to purchase the gear set. New question: Attached is a list that shows shims for this engine on an on-line parts list for this particular engine. I will need to replace shim #7 that rides on the top of...
  2. frustratedboater

    Suzuki DF225 Pinion Gear source

    I thought so. I appreciate it
  3. frustratedboater

    Suzuki DF225 Pinion Gear source

    Any suggestions or recommendations?
  4. frustratedboater

    Suzuki DF225 Pinion Gear source

    I have a friends 2010 Suzuki DF225TXX lower unit that I'm rebuilding for him. It was pretty bad with some salt corrosion and the case had a crack by the hub. Through this process I had discovered that the pinion gear is cracked and looking to replace it and the pinion bearing as well. Is there...
  5. frustratedboater

    1970 Evinrude 18hp Trottle issue

    I wish I could. My meter (the one I purchased) 400 is the lowest. I'll see if a friend has one that low. Thanks!
  6. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Coil testing question on this motor. I have a multi meter and performed the following tests on the coils: and the lowest setting starts at 400 ohms. Disconnected and isolated each coil and was getting 000.6 from both primary wires. When I touched the spark lead and the black ground nothing...
  7. frustratedboater

    1970 Evinrude 18hp Trottle issue

    I did purchase a new compression tester and still got 70 on each cyl. and should be 110 ish' I tested it to my compressor just to test and seemed correct. the reeds were all seated. I believe I did run the head over 220 and saw no depressions. I'm out of town now. I'll straight-edge both...
  8. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Just to circle back on this motor and completed the following: -I had split the case, replaced the rings, honed cly's, and new head gasket. -Checked the carb for the 6th time over and high speed jet is clear. -Ohms tested the coils and .007-.006 (going off memory-out of town). -Points...
  9. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Gotcha Think I'l check ignition but really think the rings just need replacement and a good cross-hatch cyl. hone
  10. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Therm is fairly new and operated during test.
  11. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Agree and will do that. Everything looks black and slightly oily. Cause of the black?
  12. frustratedboater

    1970 Evinrude 18hp Trottle issue

    I appreciate the detail.. yes, went through the carb 3 times and the low & high speed fuel circuits are clear. I'll check the timing and see whats going on. Strange thing is right at 3/4 throttle it dies off fast but gradually like its running out of fuel. The pump is new and there is fuel...
  13. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Here is the head and gasket. Looks pretty solid and no signs of loosing compression. cyclosp mentioned: black oil. What is the story behind that?
  14. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Yes, I usually give it at least that to build the most pressure.
  15. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Wouldn't water be entering if bad? Where would the compression be going..through the water passage?
  16. frustratedboater

    1970 Evinrude 18hp Trottle issue

    I'll give it a go. I appreciate it
  17. frustratedboater

    1970 Evinrude 18hp Trottle issue

    I did see a little black oil, but not a lot. There was some collecting in the lower by-pass plate. The plugs had a little but not excessive
  18. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Spark jumps 1/4" on #1 & a little less the distance on #2
  19. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Here's from my scoping tool: walls look great.. without splitting the case, and given the year, would you throw the chips on tired rings? same compression on both cyl's.
  20. frustratedboater

    1970 Evinrude 18hp Trottle issue

    Side wall:
Top