1990 v-200 Stator Test? (5454A34)

[danamul1977]

I've been having problems bogging down at 2500-3000 rpms under load so I wanted to test the stator. Wondering if these #'s are to low and would cause the problem. Book says (between blue and red wires, 4450-4600ohms) mine is 4130. Between blue/white, red/white 4450-4600ohms, Mine is 4170. Everything else tested ok, (triger was ok). Would this cause a high speed problems under load.

Also wondering if it matters what yellow stator wire goes where on the rectifier. Is their a high speed wire and low speed? I need to know how to reconnect it, they seem to be the same. TY

 

[Dukedog]

if it won't pass tha ohm test its weak.... bad high side usually won't let tha motor turn over 3 grand at most...
yellows are chargin' circuit.. either pole on rectifier long as its not tha one marked +.........

strange, not many 16 amp '91 200's around.. same stator used ona 2.4 bridge port!

 

[danamul1977]

ok ty, that's prob my problem then