Hallo , i have a litle (or verry big) problem , i recently bought a 33 h.p (with a hood of a 40)and if i put the spark plugs (short shaft) QL77jc4 and gaped them (2 cilinder)and put them in , and cranked the engine , it wil not run ,and after checking the plugs for fuel , i noticed that both pistons have hit the spark plugs , and closed the gap to 0,00 mm , i put in 2 (new)plugs from another engine , with solid gap , i mean those spark plugs without gapping posibility , because ther is no gap the spark plugs are 3 mm shorter , and the pistons dont hit them (UL18V), after cranking the engine ,the engine started and idelt for 6 seconds with a lots of smoke , my bad mix oil /fuel was 20:1 , i know now that the mix has to be 50:1 , but what about the spark plugs , what do i have to put in , compresion is very high , the engine sounded very good ,smooth for 6 seconds ,and then it stalled , i am trying to get the flywheel of to take a look under the flywheel ,to clean points or check the points , touch flywheel,does not want to come of , i would like any kind of information that could help me , figure this out , thank you for reading and greetings
info i got on my engine is : year 1966 model RX14 h.p 33