Need help finding an upper yoke input shaft for bravo one

[ryan04]

Hey folks! I just swapped in a new engine coupler in my 2006 5.0mpi with a bravo one drive. When the coupler went it chewed up the input shaft/upper yoke on the drive. I've been looking to replace that shaft but it's proving quite difficult to find one that doesn't cost 500. It's a 17 spline and the retainer clip is on the INSIDE face of the U joint housing NOT on the outisde snapped around the U joint itself.

Which leads me to my question. I've found bravo X input shafts that appear to be the one I need for my 2006 bravo one. Will a bravo X input shaft fit a bravo one drive? It's the same length and has the retatiner clip on the inside face like mine.

Anybody have a line on a good used one?

Thanks!!

 

[alldodge]

There the same length but the U joints are different

Measure the inside and the Reg Bravo will be a tad larger then 1.079, the X will be a tad larger then 1.329 or 1.218 (meaning s/n 0W1000001 and below and 0W1000001 and higher)

Ask at OSO wanted section, someone probably has one

 

[ryan04]

There the same length but the U joints are different

Measure the inside and the Reg Bravo will be a tad larger then 1.079, the X will be a tad larger then 1.329 or 1.218 (meaning s/n 0W1000001 and below and 0W1000001 and higher)

Ask at OSO wanted section, someone probably has one

Thank you kind sir!!

 

[ryan04]

Thank you kind sir!!

I can't find the OSO wanted section. Are you able to point me toward it?
Thanks again!

 

[alldodge]

Its in the Marketplace area, heres a link
https://www.offshoreonly.com/forums/wanted-244/