baconbiscut
Petty Officer 1st Class
- Joined
- Jul 11, 2006
- Messages
- 364
Today I took our 25 ft cruiser out when the tank read empty and cruised around for while And then went over to a club and after going there for about an hour or so i decided to bring it in for the night. As I pulled up to the boat house the engine began shaking and thats when I knew that all cylinders were not fireing and that I was running out of gas. Sure enough when I entered the boat house the motor cut off. So i went and got the five gallon jug and pored some gas back into the boat oh and by the way it has an 85 gallon tank. After 3 attemps the motor started up on what sounded like two or three cylinders. While the engine was running it sounded pretty smooth. I decide to put into throttl only mode and rev up to about 2500rpm. When I did this the engine would run smooth then it would shake and drop about 200rpm then it would go back to sorta smooth then really smooth where it would gain 200rpm. So all in all I would adjust the throttle to 2500 rpm then it would drop to 2300 rpm then back to 2500rpm and then to 2700rpm.
The boat was repowered in august with a 2008 383 MPI mercruiser engine 6.2 it has about 35hrs on it.
The boat was repowered in august with a 2008 383 MPI mercruiser engine 6.2 it has about 35hrs on it.