wpchrist
Seaman Apprentice
- Joined
- Jun 15, 2015
- Messages
- 43
Hello all,
I just bought a used 2017 Yamaha F150XCA. I put it on my 2005 Hurricane deck boat. I also bought the boat used with no engine.
I have a couple of questions
The Harness from the binnacle has a round ten pin connector on the engine end. There are also two square four pin connectors. I looked extensively on the engine but did not find a round ten pin connector, just a square yellow connector with about 14 wires. The binnacle is the original sidemount.
Is it possible to use this binnacle and harness from the binnacle to the engine or do i need a new binnacle and/or harness?
The gauges are analog but new. The picture shows the old gauges.
Can I use these analog gauges with this engine? The dash configuration makes it awkward to try to fit any other type gauges.
Thanks in advance for any help!
I just bought a used 2017 Yamaha F150XCA. I put it on my 2005 Hurricane deck boat. I also bought the boat used with no engine.
I have a couple of questions
The Harness from the binnacle has a round ten pin connector on the engine end. There are also two square four pin connectors. I looked extensively on the engine but did not find a round ten pin connector, just a square yellow connector with about 14 wires. The binnacle is the original sidemount.
Is it possible to use this binnacle and harness from the binnacle to the engine or do i need a new binnacle and/or harness?
The gauges are analog but new. The picture shows the old gauges.
Can I use these analog gauges with this engine? The dash configuration makes it awkward to try to fit any other type gauges.
Thanks in advance for any help!