Teleflex steering install issue

[danhend]

OK, per my last thread, I had to remove my motor in order remove the cable from the motor mount, and I have done that. The new Teleflex cable is attached, the motor is attached and the engine hoist is returned to Lowes.

My new issue is at the other end. I am unable to remove the steering wheel to replace the assembly. I was able to detach the 3 screws holding the assemblt to the mounting plate, but the steering wheel will not come off so I can remove the whole assembly.

I have unscrewed the lock nut from the center of the steering wheel, but there is no movement. Is there something about the Woodruff Key or a trick to snap the wheel free? Otherwise I am hack sawing away. Seems like I am missing something.

 

[aleutianwest]

Re: Teleflex steering install issue

put the nut back until flush pull up on steering wheel and hit the shaft with a hammer if you have a helping hand . hold a piece of wood on shaft and wack it hard

 

[5150abf]

Re: Teleflex steering install issue

You need a puller for that, you can get one a any auto parts store for $15-20 bucks.

It is kind of a peace sign with an extra leg, you put bolts through 3 of the holes and screw them into the steering wheel and tighten the center bolt and it will pull the steering wheel off, just ask for a steering wheel puller, they will know what you need.

That is on a tapered shaft so as you tighten the lock nut it pushes the wheel onto the taper.

I would watch the "beat it till it comes off" method, if you beat it hard enough you can break your dash or ruin the head unit for the steering.

 

[tashasdaddy]

Re: Teleflex steering install issue

really bad cases the puller can be necessary. i have never needed one. i scrunch down put my knees behind the steering wheel, and give a couple of good raps the the center bolt and they pop off.