Hello again,I am almost now ready for the big launch and have been finalising and fitting all my assemblies that were done over winter, But on checking control box and cables again after running engine in tub (runs idles perfectly)throttle cable does not give enough travel to allow wide open throttle! at full travel on box ie handle full forward there is about 1.1/4inch movement required on carb cam to full throttle, My engine is Evinrude 40hp BE40ELCR 1984 with OMC single lever control box, this set-up had new cables fitted before I purchased, I notice that the inner cable is for shift and outer cable is for throttle, what is easy way to set this up? should I screw cable adjuster to get WOT or will this upset my idle which is perfect, I have Clymer manual which has fried my brain, easy method required please, launch postponed again! thanks all, JBD also did search with no results using Throttle.
