What is this connector? 60HP four-stroke tiller

[Lewis]

The reason I ask is that I am considering adding an additional trim/tilt switch, and I hope that this connector is meant for that. I used to have a two-stroke Mercury 60 tiller with a remote tilt switch, and the switch is still there. Muscle memory has me using the switch even though it is no longer connected to the new four-stroke, so I'd be thrilled if it would be a simple hook-up to get the switch operational. The wire colors from the switch that I had connected to the two-stroke are light blue, light green, and orange just like this connector (no white to the switch, just blue green orange to the switch). Thanks for any insight!

 

[Lewis]

Now I'm thinking that's the Vesselview terminator. I guess just a coincidence that it has the exact wire colors to match the trim/tilt on the old two-stroke?

 

[flyingscott]

Looks like Tilt and trim colors. Follow them back and see if they go to the relays.

 

[Lewis]

Thanks, flyingscott. Even though they do look like the right colors, I'm pretty sure I remember removing and re-installing that terminator when I put in the Vesselview, so I'm not sure I want to mess with them.
I had trouble following those wires through the various harnesses, but I don't think they go to the trim/tilt relays. Certainly not via any remotely direct route!
On the positive side, I found that there is enough slack in the wires to the cowl-mounted trim/tilt switch so that I could tap into those if I choose to.