Where to find aftermarket impeller by dimensions

[WesleyB]

Looking for suggestions on where to find an impeller with these dimensions.
I have looked at ********** --http://www.***************/WestAdvisor/Impeller-Replacement-101-- on the Jabsco parts lookup and couldn't find close enough dimensions.


6 fins
through hole pin drive
width of impeller -- .535 inches <-- give or take a few thousands.
Outside diameter -- 1.60 inches <-- again give or take a few thousands.
Inside diameter (bore) -- 0.40 inches

The impeller is for a 1978 Spirit (Suzuki) DT4D. When I look up parts it shows the impeller as being obsolete.

So, thought I would look and see if I can find a reasonable replacement.


And, while we are on the topic.
How much should an impeller flex when putting it back in the pump housing? Eyeballing the impeller I just put back in it seemed like the impeller diameter was about 1/16 inch larger diameter than the housing. <-- The rest of this story is a topic for a different post.

Thank you in advance for any suggestions.

 

[Fun Times]

Hi there, welcome to iboats! Try following along with the replacement guide linked below to see if you can find a new impeller. Hope this helps, Good luck.

http://www.jamestowndistributors.com/userportal/document.do?docId=732

 

[brim_buster]

there is one on ebay for 14.00 free shipping..:facepalm:

 

[brim_buster]

eBay item number:​

301192012298

​

 

[bruceb58]

Hi there, welcome to iboats! Try following along with the replacement guide linked below to see if you can find a new impeller. Hope this helps, Good luck.

http://www.*************************...t.do?docId=732

http://www.jamestowndistributors(dot)com/userportal/document.do?docId=732

replace (dot) with .

to get the link to work